disco wide angle rear prop??

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
A

adam300tdi

Active Member
Posts
639
rang up lrs offroad and tryed to order a pair of wide angle props for a 300tdi disco.front 1 they said ye thats fine and the rear,they said theres no such thing as a wide angle rear prop for a disco.is that true??
 
jamesmartin said:
youd need to remove rubber dough nut and fit 4 bolt flange with 200 tdi prop ,google frc8387
Click to expand...


WHS - this will easily cope with an extra 4-5" droop angle if not more, after that there are other wide angles available but are specialist made ones I believe....
 
Last edited:
so he was right.u cant get a wide angle 1 for a 300tdi but can for a 200tdi.he said that the rear would be fine with a 4inch lift but lookin at it the rubber donut is on a real angle and doesnt look great to me just guna get a 200tdi prop
 
adam300tdi said:
so he was right.u cant get a wide angle 1 for a 300tdi but can for a 200tdi.
Click to expand...

That's not what you quoted:

Adam300tdi said:
they said theres no such thing as a wide angle rear prop for a disco.
Click to expand...

Granted, the 300tdi requires the 200tdi set-up, but it's still a wide angled prop for a Disco, and the only thing separating the 2 is a simple 4-bolt flange kit.
 
Last edited:
when i rang up he just said you cant get one for the rear because of the length of them.there long enuff to not be effected by the angle increase
 
adam300tdi said:
when i rang up he just said you cant get one for the rear because of the length of them.there long enuff to not be effected by the angle increase
Click to expand...
its not the length but angle of diff ,it is more straight than the front ,and theres no point with wide angle at one end with rubber doughnut at the other ,part suppliers dont allways have the best knowledge depends if theyve actually real experience
 
good idea ,dont forget when fitting 4 bolt flange ,earlier flange needs a spacer fitting first the later flange has spacer in built ,you can check against length of your 3 bolt flange which also has spacer built in
 
You must log in or register to reply here.

Similar threads

19_Hue_95
300tdi Poptop Camper
Replies
0
Views
1K
19_Hue_95
19_Hue_95
M
Advice on replacing both rear toe spindle links on Disco 4
2
Replies
29
Views
3K
Anaconda
A
Hammer'n'tongs
Tyres wearing unevenly:- Axle ends out of alignment
Replies
9
Views
2K
Hammer'n'tongs
Hammer'n'tongs
Goc3k
Discovery 1 SOLD 1997 300TDI manual D1, Winchester
Replies
16
Views
4K
Goc3k
Goc3k
M
Freelander 1 REAR PROP SHAFT
Replies
11
Views
2K
Dar ran Dar ran
Dar ran Dar ran
Back
Top