Disco 2 non Starter

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Hi Mate,

No problems, Unfortunately, one of those things where you need to go thru it step by step, see where you should be getting voltage, If you do move on to the next /previous step in the system that should be seeing voltage, rule out the easy stuff to check before you start looking at the BCU , internal fusebox, IDM inputs/ outputs etc.

Although another thing to check quickly is if you have water damage on the Internal fuse box IDM. as this is a common fault on them if water has got inside.

Also make sure your battery is fully charged up and kept that way while trouble shooting, to avoid getting yourself confused by a low battery.

As said above by @Vanmancan, check and clean all earths you find, which is always good advice to do anyway to avoid dodgy issues.

Cheers
 
If fuse F23 interior fusebox is good and you dont get 12V on the starter relay's coil(on one of those terminals which are parallel to each other) the problem is on that path somewhere, could be the crank contact in the ignition switch, , to rule this out see RAVE - Electrical library - Connector views - C0028, put ignition on 2 and give 12V with a wire into that connector's pin 6(white/red wire) just remove that feed if it starts... if it does the problem is the ignition switch
 
Thanks guys-gonna investigate further next week when off work.
Currently starting her with a push button in line on a cable from starter to battery. Works for now

Got rid of the amigos and brake warning light.One of the front hub bearings was worn so replaced hub,rotor and pads then had my local LR guy reset the codes. Job done.

Just top radiator hose to change today then starter problem next week and I'm done .....for now lol.

Oh and I changed the drivers seat yesterday.

Thanks for all your help everyone.
 
Back
Top