Hi td5 gurus can anyone tell me the correct priming sequence following the fitting of the in tank pump. The car runs but dies like its sucking air. I 1st turned ignition on and waited untill the pump went quiet then started it. If it then dies its a sod to start. Any advice is welcome at this stage.
Disco 2 fuel priming
- Thread starter nizbang
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
sierrafery
Well-Known Member
- Posts
- 17,801
- Location
- Arad/Romania
Turn ignition on 2 then push completely and consecutively the throttle 5-6 times utill the MIL starts flashing then wait untill it stops(around 3 minutes) then ctrank it.
Ok primed it properly and ran ok but lost power half a mile then cut out again. Changed fuel regulator and diaphram still cuts out. After its cut out you prime it 3 or 4 times and it will run for half a mile. So in tank pump changed fuel regulator changed fuel filter changed. Had noticed a lot of blue smoke now tho.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
presuming pump and filter have pipes connected in the right order,id change air bleed valve as a matter of course and injector washers plus orings
sierrafery
Well-Known Member
- Posts
- 17,801
- Location
- Arad/Romania
+1 for injector seals(copper washers are causing such symptom)
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
rear outer connector on filter head
Flock
Member
- Posts
- 11
- Location
- Nottinghamshire
Having the exact same problem!!!
Flock
Member
- Posts
- 11
- Location
- Nottinghamshire
Dumb question what actually is right order?
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
pump from left as you look at white,green ,blue, black
filter head inside front return from head, outside front filter to hp pump black,outside rear white air bleed valve return,inside rear blue lp pump feed to filter
filter head inside front return from head, outside front filter to hp pump black,outside rear white air bleed valve return,inside rear blue lp pump feed to filter
Flock
Member
- Posts
- 11
- Location
- Nottinghamshire
Yea they right, i think mines alternator, when in 2nd position on key battery light doesn’t go out like it should before starting, so borrowing a charger and charging battery if it starts I know it’s that! 99.9% sure it is, have a feeling!
sierrafery
Well-Known Member
- Posts
- 17,801
- Location
- Arad/Romania
It should go out only AFTER the engine was started and running... and this thread is about something else Similar threads
