P38A Diagnostic port

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Grrrrrr

Grrrrrr

Technician, Bodgit & Scarper Ltd
Full Member
Posts
19,312
Location
Buckinghamshire, UK. ('95 DT)
Looking at the OBD plug on the scrapper because it doesn't work. There's a spare red and grey wire at the back. Is that normal?! Should it go somewhere? No spare bits of metal that I can see.

Checked all fuses in BECM and they're all good. Any other ideas? I think this isn't @tomcat59alan 's first rodeo.
 
It certainly is isn't,fuse 33 5 amp is the power to the odb plug pin 16 pins 4&5 are ground.its a brown wire from 16 that runs under the heater and is spliced at the right hand side of the heater to a brown wire that passes through the bulkhead and comes out under the header tank in the main loom then on to the fuse box.;)
 
tomcat59alan said:
It certainly is isn't,fuse 33 5 amp is the power to the odb plug pin 16 pins 4&5 are ground.its a brown wire from 16 that runs under the heater and is spliced at the right hand side of the heater to a brown wire that passes through the bulkhead and comes out under the header tank in the main loom then on to the fuse box.;)
Click to expand...

Cheers. I'll try and have another look tomorrow. I only recall about 8 wires going into it.

The connector behind the kick panel was green and 1 pin fell out when I pulled it apart.
 
tomcat59alan said:
It certainly is isn't,fuse 33 5 amp is the power to the odb plug pin 16 pins 4&5 are ground.its a brown wire from 16 that runs under the heater and is spliced at the right hand side of the heater to a brown wire that passes through the bulkhead and comes out under the header tank in the main loom then on to the fuse box.;)
Click to expand...

Brownie point to Mr Cat: fuse 33 it was. Thanks. Now, what horrors await?!
 
Hmmm. Cannot get into EAS. EDC was a bit hit and miss too. Managed to turn off immobiliser and EKA which should save a lot of messing about.

Easier to start than yesterday which makes me suspect leak off pipes are living up to their name.

Now, back to weeding!
 
You must log in or register to reply here.

Similar threads

R
Disco 2 Dash back lighting and switch illumination issue
Replies
2
Views
311
Stanleysteamer
Stanleysteamer
Stev
suspension in extended mode and Suspension failure
2 3 4
Replies
68
Views
7K
Stev
Stev
ChrisBduck
3.6L Land rover 90
Replies
2
Views
991
ChrisBduck
ChrisBduck
Brown
TD5 electronic faults - any ideas?
Replies
15
Views
2K
Brown
Brown
SpiritSE
L322 RangeRover L322 suspension issue
Replies
9
Views
1K
stuu
stuu
Back
Top