Clutch
- Thread starter Nev
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
doobie
Active Member
- Posts
- 807
- Location
- North East of Scotland
i've had the little catch that prevents accidental engaging of reverse gear jam before, that prevented me getting reverse gear but didnt involve any grinding noises. its an easy check though; if you look at the slots where the gear stick selects the gear (you'll need the transmission tunnel out) you should be able to see the spring held flap, mine was only held on with one screw and had gone squint preventing it from lifting. if your lucky you may hae a similar easily resolved fault!
Possible air due to something worn, try pumping the clutch a few times in succesion then try reverse.
Usually if the pressure plate goes it's the opposite heavy and crunchy gears, same if the plate is sticking on the gearbox shaft. So I would go for air in the system.
If pumping it works look for leaks, or if the slave cylinder is loose.
steve2286w
Well-Known Member
- Posts
- 4,574
- Location
- monkeyangerland
can you actually get it into reverse and when in no grinding?
the reverse selector pinch bolt could be loose, would need taking top off g/b to check
may be able to see condition of teeth on reverse gear when off
the reverse selector pinch bolt could be loose, would need taking top off g/b to check
may be able to see condition of teeth on reverse gear when off
Similar threads
