Disco 2 Can't do key programming- key not detected

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

Master808

Member
Posts
44
Location
Lancashire
Hi all. Just bought a spare key to my Disco and tried the key programming with Nanocom but without any luck. I am doing the whole programming but at the end there is still information NOT DETECTED. Old key works 100% fine, locks and unlocks the car so the RF is working fine. As well I have tried to code new key i other Disco 2 which worked. Any ideas? Is that a BCU fault?
 
Yes, I have done it through Nanocom video from their website so the procedure is 100% right as I have checked it in another Disco 2.

I have tried in every slot apart from the one that the original key is programmed cause I didn't want to delete it.
 
I think I have found the problem. It looks like the RF Receiver isn't working as it should. If I go to the front of the car, it doesn't won't to open it, but when I lift my hand up or get it closer to the sunroof it works. Is there any way to clean it or make it stronger or should I just replace it?
 
Check the connections and the earth on the RF rec. Others have dried a unit out by leaving it overnight on a radiator.

Cheers
 
You must log in or register to reply here.

Similar threads

L
Disco forgetting key/immobiliser
Replies
7
Views
508
R-Two-D2
R
MAF Diver
Disco 2 Nanocom/RAVE manual is wrong: adjusting windows after removing key and opening a door?
Replies
4
Views
527
MAF Diver
MAF Diver
S
Ace warning removal
Replies
3
Views
744
Sean1319
S
C
D2 2004 td5 no start immobiliser
Replies
1
Views
803
Chips666
C
G
Td5 central locking (another one)
Replies
3
Views
848
sierrafery
sierrafery
Back
Top