Freelander 05 1.8 3 door
Have just replaced head gasket myself,
Head tested and skimmed
Oil seals changed, values cleaned and re-seated
Had new MHG kit including bolts
Cleaned sump and oil ladder
Cams clean and new oil seal to both cams
Change all drive/cam belts
New water pump
New Spark plugs
New coolant and oil for engine, gear box and both drive boxes,
So just tried to start the car, and all Im getting is nothing, started motor turns and but no ignition form any of the 4 cylinders.
Have checked timing which I think is correct, spark plugs and fuel pump working fine, engine is turning from pulley bolt by hand fine and from starter motor which is again fine.
Car was working before I started the work and turning over fine, but will the fault of the HG going, does anyone have any clues where to look next and more so how.
Have just replaced head gasket myself,
Head tested and skimmed
Oil seals changed, values cleaned and re-seated
Had new MHG kit including bolts
Cleaned sump and oil ladder
Cams clean and new oil seal to both cams
Change all drive/cam belts
New water pump
New Spark plugs
New coolant and oil for engine, gear box and both drive boxes,
So just tried to start the car, and all Im getting is nothing, started motor turns and but no ignition form any of the 4 cylinders.
Have checked timing which I think is correct, spark plugs and fuel pump working fine, engine is turning from pulley bolt by hand fine and from starter motor which is again fine.
Car was working before I started the work and turning over fine, but will the fault of the HG going, does anyone have any clues where to look next and more so how.