ant.7
Active Member
- Posts
- 213
- Location
- gatley, cheshire
hi guys
please help im losing the will to carry on with my 1996 300tdi disco.
problems are as follows
high pressure in header tank
heaters hot / cold intermittent
struggling to bleed system
top hose from rad cold
things ive tried so far
changed thermostat
changed temp sender unit
replaced bootom y hose from header to radiator
chaged both heater matrix hoses
water pump inspected all ok
checked bypass valve all ok
filled system through thermostat housing
filled system through radiator
took her for a drive today after taking water pump off to check and refilling system through the thermostat housing and radiator, ran great for about 10/15 mins at about 60/70mph (heater hot and temp guage normal), then heaters went cold and temp guage stated to rise, when i got back home i opened the bleed valve (b&q type) on the top of thermostat housing and hot water poured out like a jet wash, then i opened the header tank and hot water spewed out under loads of pressure??
any ideas what to try next?
im certain its a blockage of some sort?
ive read loads of posts on here but nothing really has the same symptons well not that ive found?
thanks as always
tony
please help im losing the will to carry on with my 1996 300tdi disco.
problems are as follows
high pressure in header tank
heaters hot / cold intermittent
struggling to bleed system
top hose from rad cold
things ive tried so far
changed thermostat
changed temp sender unit
replaced bootom y hose from header to radiator
chaged both heater matrix hoses
water pump inspected all ok
checked bypass valve all ok
filled system through thermostat housing
filled system through radiator
took her for a drive today after taking water pump off to check and refilling system through the thermostat housing and radiator, ran great for about 10/15 mins at about 60/70mph (heater hot and temp guage normal), then heaters went cold and temp guage stated to rise, when i got back home i opened the bleed valve (b&q type) on the top of thermostat housing and hot water poured out like a jet wash, then i opened the header tank and hot water spewed out under loads of pressure??
any ideas what to try next?
im certain its a blockage of some sort?
ive read loads of posts on here but nothing really has the same symptons well not that ive found?
thanks as always
tony