- Posts
- 2,427
- Location
- Isle Sheppy
Brit car bearmarch stopped trading any updates
P38A Bearmach
- Thread starter pete12345
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 2,427
- Location
- Isle Sheppy
- Posts
- 16,479
I needed a steering knuckle for the FL2 - Bearmach were knocking them out at like £45 as clearance - I asked why, they said they were closing...sad to say the least!
- Posts
- 19,309
- Location
- Buckinghamshire, UK. ('95 DT)
I've found a bunch of Hawkeye unlock codes in a drawer. Do you think there's any chance to get them to work now that they're no longer on the market?
Try the number but doubt it.
Salisbury Nick
Well-Known Member
- Posts
- 790
- Location
- Dorchester
Thats sad news. I used them regularly.
Marshall8hp
Well-Known Member
- Posts
- 297
- Location
- Sydney
Perhaps a decline in the quality of their product? I used to always use Bearmach, but in the last couple of years I had trouble with the quality, part not fitting, manufactured incorrectly etc. The last one was a flexible steering shaft for the P38. The spline for the steering column end was the wrong size (too large) so it couldn't be tightened up. When I got in touch I was told they would refund, toss it in the bin, we can't replace, all the rest of the stock is the same.
- Posts
- 19,309
- Location
- Buckinghamshire, UK. ('95 DT)
Yep. I had some P38A engine mounts of theirs and the ****er sheared off torquing it up. Looked and you could see the crystalline structure of bad casting. I had to put the originals back on.
