Be this my gearbox drain hole?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

gR@HaM

Well-Known Member
Posts
1,095
Location
Cheshire
Just noticed what appears (to me) to be a missing gearbox drain plug behind the sump can anyone confirm?
If so, should I be concerned for my autobox?

DSC01494.jpg


DSC01495.jpg
 
That is your bellhousing drain hole. The idea is that IF any oil leaks through the rear engine oil seal it doesn't get trapped in the bellhousing and muck up your clutch.

Only block off when wading through water.


okay, thanks - will have a look see to find where the oil has come from. Might just be the mess I made when draining the engine.
 
Seriously - go with Andy on this - get yerself a new seal asap.

I just had to replace mine as it was becoming more of a trickle than a drip. Twas fun ... now all i gotta do is put the crutch back in, stickbox thing back on and the spinning thingies that come out of it.
 
Last edited:
Yeah - i's a pain in the proverbial. But, TBH, if theres a leak, it needs sorting.

In the defenders its easier to drop the boxes - the floor panels can come out. Discos you gotta work from underneath.

The good thing is the oil seal on the 300 is **** easy - 5 bolts and the whole plate and seal come off.
 
^^^ Thats for a manual box. Entirely different situation removing the box (or engine) if you have an auto.

Is it more work with an auto?
Would it be the kind of thing a reasonably competent home mechanic can do? This is my first project, coping okay so far doing a recon cylinder head (although cant fire it up yet until I get the fuel tank back in), attacking all the rust etc..
 
There is an 'inspection' plate that you have to remove and thru that you have to undo 3 (?) bolts that hold the torque converter to the flex plate. Then when you move the box back or the engine forward you have to make sure that the TC is retained with the box and engaged in the pump.

Be careful as the TC will contain some ATF; you will need a catch tray to hand.
 
There is an 'inspection' plate that you have to remove and thru that you have to undo 3 (?) bolts that hold the torque converter to the flex plate. Then when you move the box back or the engine forward you have to make sure that the TC is retained with the box and engaged in the pump.

Be careful as the TC will contain some ATF; you will need a catch tray to hand.

Thanks, sounds fairly straight forward will try and dig the haynes out..
 
It won't all come out if you keep the box fairly level :D


Hiya mate, I wasn't referring to the oil in the box, as that can be drained out in the normal way - I was referring to the oil in the TC and I'm not sure how you get that out, as part of the 'box removal procedure?
 
Back
Top