A-Frame Ball Joint renewal

woods767 · Mar 3, 2009

Ive got the assembly off the Landrover, and after about half an hour of intense abuse i got the old ball joint out of the fraim. But now i cant get the new one in, not even when i used the hi-lift as a clamp to press it in.

I know its supposed to be tight, anyone else here had to change one of these, how did u get the new one in?

Rich.

Trewey · Mar 3, 2009

I de-burred the bracket a bit, with a half-round file, then applied some copper-slip.
I could then (just) get the new joint to go in with the aid of a big vice and lots of heaving and swearing.

woods767 · Mar 3, 2009

Im going to take it to an engerneering company down the road tmorrow. I dont realy want to bore it out anymore because i know it needs to be pressed in properly, thats how it works. I dont have a vice eather, so id just end up hitting it with a big hammer again.

jai_landrover · Mar 3, 2009

Woods have you sorted your diff yet?

Sounds like all the mechanical bits on your mota are all falling apart, whats happenin? Jai

woods767 · Mar 3, 2009

jai_landrover said:
Woods have you sorted your diff yet?

Sounds like all the mechanical bits on your mota are all falling apart, whats happenin? Jai

Make no mistake, the non-mechanical bits are falling appart aswell.

Its mostly due to neglect from previous owners (20 years of maintinance to catch up with), and general off road abuse from its current owner.

bustersbus · Mar 3, 2009

woods767 said:
Im going to take it to an engerneering company down the road tmorrow. I dont realy want to bore it out anymore because i know it needs to be pressed in properly, thats how it works. I dont have a vice eather, so id just end up hitting it with a big hammer again.

That's what ah did... much easier

A-Frame Ball Joint renewal

woods767

Well-Known Member

Trewey

Cockernee, Pasty munchin bastid.

woods767

Well-Known Member

jai_landrover

Well-Known Member

woods767

Well-Known Member

bustersbus

Well-Known Member

Similar threads