93 RR Need wiring Diagram

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

edorc

New Member
Posts
68
Location
Dorset
Hi, Anyone out there got a wiring diagram for a 93 V8 petrol Rangie? My copy of RAVE only has a 95 version on it. :doh:
Unless someome says thats the same, which I doubt!)
Heres hoping!
 
I am looking for the wiring connected to the heater fan motor in particular. Mine only runs at full blast so I suspect the resistor may be at fault.
 
I am looking for the wiring connected to the heater fan motor in particular. Mine only runs at full blast so I suspect the resistor may be at fault.

Hahaha mine has just done that as well!!

The problem is that the resistor for the motor is inside the heater housing. You need to remove the dash to get at it. Definately a summer job. Come to think of it, you'd need to remove the dash to be able to fully test the circuit because the motor and resistor are both inside the heater housing.

I suppose you might be able to get in there and get it sorted in a day but I'll bet it'll end up being a whole weekend, you just know it will. In this cold snap I'd not risk it, let the heater run flat out as long as it runs. If it gets too hot in the car, run the A/C as well or use air recirculation through the main dash vents.
 
Thanks for the reply. It confirms what I suspected..a small part replacement being a major strip down job! Shall most certainly wait till the summer!!
 
Thanks for the reply. It confirms what I suspected..a small part replacement being a major strip down job! Shall most certainly wait till the summer!!

Not sure about 93 mod, but my 94 mod I can access resistor through the glove box, just remove glove box first and see if yours is accessable from there first.
 
Back
Top