mike penketh
Member
- Posts
- 22
just fitted a 4 pin 24 spline rear diff to my 1976 v8 classic, range rover.I was given a 24 spline defender pair of half shafts with moulded drive flanges only to find today they dont fit?
1 the end drive flange is of the shallow type and wont seat over the ajusting nuts and washers from the stub axle
2 the half shaft has a surface ground largear area near the drive flange that will not go into the stub axle hole
does anyone know what kind of shafts i should be using to get over this problem ? and were to get them from
1 the end drive flange is of the shallow type and wont seat over the ajusting nuts and washers from the stub axle
2 the half shaft has a surface ground largear area near the drive flange that will not go into the stub axle hole
does anyone know what kind of shafts i should be using to get over this problem ? and were to get them from
