jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
you havent read my post then,
just watch valves open and close fully in turn by turning engine by hand
200tdi cut out and will not restart
- Thread starter dag019
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
just watch valves open and close fully in turn by turning engine by hand
I did that when I first replaced the push rods and the again as I set the valve clearances. They all open and close as I would expect. What should I be looking for?
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
that would suggest they are ok
Then that brings me back to why am I getting chuffing “exhaust” fumes coming out of the intake manifold.
If to check them all I need to do it remove the rocker shaft and put a straight edge along themI will do that now.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
id compression test it,have you had head off and are the threads above the rocker adjuster equal
Last edited:
I have not had the head off. Was trying to avaoid that. Have just removed the rocker shaft and the valves all line up on a straight edge both with and without the valve caps fitted.
What do you mean by the threads on the rocker adjuster? Is that the lock screws for adjusts the tappets? If so yes they are all equal.
I am trying to upload a video of what happens when I turn it over. But it seems iPhone does not have the correct file extension to upload.
Last edited:
video now uploaded, you can see what I am assuming is unburnt fuel coming out the intake. Is there anything else I can do without taking the head off, as to pressure test @Kwakerman suggested the timing needs to be set up correctly.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
says video unavailable,how did you set tappets
Just to clarify, what I said was that the timing needs to be correct for a compression test to work properly (on any engine) otherwise the valves would open / close at the wrong time so you would get an incorrect reading. Also said that timing looks ok from your pictures. One other possible option may be a leak down test, that is carried out at tdc on compression stroke so if you have clearance on both rockers at tdc and if the leak rate is enormous and you can feel air coming out the intake you know a valve is open or isn't sealing, however you would still need to determine why
Take the rocker shaft and rockers off so that all valves are closed at the same time to carry out a comparison
Well I can see this, can't you?
I get it now I am on the laptop, don't get them on my phone when in the garage.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
either a valve or more aint sealing ,head gasket blown between two or timing,timing looks right but is cam key ok
Another thing to try is turning the crank to tdc making sure the crank woodruff key is vertical. in that position both No 1 and No 4 pistons will be at tdc so on one of those cylinders both intake and exhaust valves should be shut and have the 0.2mm clearances. If neither sets of valves are fully closed then it looks like the cam timing is out.
What do you mean the cam key? Are you suggesting the cam timing cog has slipped on the shaft? I will check that in the morning.
I will also check the valves and redo the timing again as see if that makes a differance. I agree is sounds like a valve is positively open which is what lead me to think the timing was still out.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
its possible with a sudden shock, you can see if you undo the bolt ,use loctite on the threads when you refit it
Last edited:
Similar threads
