2" lift freelander

hi guys please don't hammer me for doing it i know its not most peoples taste but i am lifting my freelander 2" i have ordered the lift blocks that go inbetween suspension top mounts. the only thing i need advice on with fitting is camber. i have ordered some camber adj bolts wich go in the bottom clamp of the strut but how do i set the camber do i need a camber guage and do adjustments have to be made with the vheicle's weight fully on the ground or jacked up. also do the rear have to be done too ? all advice will be much apreciated
cheers in advance guys

For a Freelander 2?

sorry my bad its a 2002 freelander 1

That's better

Where did you get the kit?

ebay http://www.ebay.co.uk/itm/272395039447?_trksid=p2057872.m2748.l2649&ssPageName=STRK:MEBIDX:IT

You fit the kit. Trim arches. Move pipes. Fit camber bolts. Drive around block to settle suspension. Grovel under it and adjust camber to get the wheel vertical at leaning in a smidge. Then get 4 wheel alignment done.

They're mine

so i just set it by eye and leaning in a little at the top ?

That's how I do it. Nice flat ground. The wheel alignment check will tell you if it's in spec. Last one I did was pretty much spot on by eye. It's easier to see than toe angle

If you want any info pm me.
Check out my store too. www.muddymods.com

thanks for advice much apreciated. ohh and do i do the rear ones too?

You can. They don't get thrown out as much. The front makes a big difference to the handling especially in the wet. I've done mine. Most don't though.

cheers m8 your store has been added to my fav too as i have just ordered some ebc pads and im wanting some grooved/dimpled disc very soon.
thanks again.

I'll be putting some cheaper ones on shortly. Pm me if you want some before I do.