08 range rover vogue 3.6 tdv8 lumpy idle
- Thread starter Jw1233
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Henry_b
Think outside, no box required.
- Posts
- 15,509
- Location
- somewhere else
Any smoke?
Could be an injector harness, Egr's, any coolant consumption?
The in tank pump itself is the exact same spec as the one fitted to the TDV6 it should give 0.6 bar with the ignition in the ON position,
A code reader will be required i'm afraid, if there is a code a missfire you will have to get the codes.
Could be an injector harness, Egr's, any coolant consumption?
The in tank pump itself is the exact same spec as the one fitted to the TDV6 it should give 0.6 bar with the ignition in the ON position,
A code reader will be required i'm afraid, if there is a code a missfire you will have to get the codes.
Last edited:
Henry_b
Think outside, no box required.
- Posts
- 15,509
- Location
- somewhere else
You could have an issue with a Fuel pressure control valve, or a fuel pump module fault
A fuel pressure check would be a good idea
A fuel pressure check would be a good idea
Maybe some dirt got into the fuel rail while the pump was being changed? This would have found its way to an injector, which wouldn't do it any good.
It doesn't need to be large lump of dirt either, just the smallest spec of dirt is enough to block an injector nozzle.
It doesn't need to be large lump of dirt either, just the smallest spec of dirt is enough to block an injector nozzle.
norseman
Well-Known Member
- Posts
- 3,279
- Location
- Essex - UK
That's the trouble with multi-cylinder engines. Back in the 'sixties a mate ran an old Yank V8 for several months before he found out it was only firing on 7 pots
