Can a repair be done small hole In Air bag on Suspension???

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

c099895

New Member
Posts
436
Location
nr Hornchurch, Essex
Hi, wondering anybody has tried a temporary repair until the bags have been replaced.. I have a small hole on an Airbag on rear offside, anybody tried it and what did they use?? I was thinking of using a motorcycle puncture repair kit on it, with rubber glue advice most welcome...
 
Tyre repairs require you to have access to the inside, so not a viable option
 
not on a temporary motorcycle repair kits, that you do at the roadside you have you push a rubber bung with glue on it. Then inflate to i.e 42 psi.. Cut the protruding end off job done.. However this is not a tyre.. Plus what psi is in the airbag??
 
From memory it takes around 80psi to start lifting the car off the bumpstops.But what the pressure gets too when the car is at height,valve closed and you hit a bump......
Stop being a tight arse and put a SET of bags on it.(If its done more than about 90k the compressor and height sensors will all be sha--ed too.)
The rest of it is reliable apart from random valve block drive pack failure.
 
I Know, I Know.. looking at prices now... Island 4x4 came recomended. [ ZR1200 ].. not sure if you get the O rings tho £229.00 inc del, £10: 00 for the clips... cant see the O rings for sale??
 
From memory it takes around 80psi to start lifting the car off the bumpstops.But what the pressure gets too when the car is at height,valve closed and you hit a bump......
Stop being a tight arse and put a SET of bags on it.(If its done more than about 90k the compressor and height sensors will all be sha--ed too.)
The rest of it is reliable apart from random valve block drive pack failure.

Everything I've read regarding the EAS system is that any components used in repairs or mods should be rated to at least 150psi! This is the figure I've worked to in adding an air take-off point.
 
I Know, I Know.. looking at prices now... Island 4x4 came recomended. [ ZR1200 ].. not sure if you get the O rings tho £229.00 inc del, £10: 00 for the clips... cant see the O rings for sale??

'O' rings are included/part of the airbag assemblies...I can't see any way of repairing an airbag, apart from replacement...
 
Cheers, John, i have a mate that knows a man at LR.. Looking at prices,. How do your Dunlops bags perform??

Dunlop airbags are standard Land Rover fitted parts, just without Land Rover/Stealers profit

The ride seems a little bit firmer with the new bags fitted, but considering the old bags were cracked and porous that doesn't surpise me.

I don't think that unless the vehicle is being used "very seriously off road", there's any advantage in Arnott airbags.

Its a comfortable feeling knowing that the airbags are in good condition and your not going to have any problems, there now't like a burst airbag with a 3 ton trailer on the hook....:eek:
 
Last edited:
Dunlop airbags are standard Land Rover fitted parts, just without Land Rover/Stealers profit

The ride seems a little bit firmer with the new bags fitted, but considering the old bags were cracked and porous that doesn't surpise me.

I don't think that unless the vehicle is being used "very seriously off road", there's any advantage in Arnott airbags.

Its a comfortable feeling knowing that the airbags are in good condition and your not going to have any problems, there now't like a burst airbag with a 3 ton trailer on the hook....:eek:

Except for the lifetime warrenty perhaps?:D Got my Gen 2's for not alot more than OEM:D:D:D
 
I doubt that you can hear the air compressor running, it's probably the ABS pump you can hear.

Why do you doubt it? I can clearly hear mine - it's a different sound to the abs pump.

I hear that replacing the rubber mounts on the compressor will quiet it down. Or fix the leaky air bag!

Guy
 
Except for the lifetime warrenty perhaps?:D Got my Gen 2's for not alot more than OEM:D:D:D

I agree Gen 2's aren't a lot more than OEM, but theres always a get out clause in warranties, usually fair wear and tear.....so what are you going claim in 15 years time when the bag goes bang after being worn though and cracked???

Copied from Arnott's web site:

What is your warranty on parts?
Some parts have lifetime warranty while others have one year. The warranty is non transferable. If a part is defective we will either replace or repair that part, as long as it is in the warranty period and proof of purchase is available. We do not offer a warranty to commercial vehicles. Improper use or installation is not a manufacturer's defect. Parts returned unused are subject to a 20% restock fee.

Good luck in years to come....;)....:eek:
 
Last edited:
Why do you doubt it? I can clearly hear mine - it's a different sound to the abs pump.

I hear that replacing the rubber mounts on the compressor will quiet it down. Or fix the leaky air bag!

Guy

I can hear mine when the engines not running just before starting, not when its running but maybe because its an oiler!!!.....:eek:
 
Everything I've read regarding the EAS system is that any components used in repairs or mods should be rated to at least 150psi! This is the figure I've worked to in adding an air take-off point.
The pressure switch stops the compressor at 10Bar,so your air take off point wont see any more than that.The pressure in the springs and lines back to the valve block will go above this when the car hits a bump,but I've never put a test gauge in a spring line to check what sort of shock pressure it gets to.
BTW,be careful using too much air from the system,the standard Thomas compressor is no more than adequate to keep the EAS going,so unless you upgrade it blowing up tyres etc is not a good idea.
 
Back
Top