Engine rebuild thread

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
When fitting the fly wheel housing the manual doesn't mention a gasket just says use
Hylogrip 2000 sealant. But there was clearly a gasket fitted as there are remnants. Do I need both?
no just gasket err1440 if it doesnt have the sealant impregnated like below use some silicone to cover the main bearing joints and sump joint
upload_2019-2-28_13-47-42.jpeg
 
Fitted the rear seal, went in a bit wonky but straightened up in the end. I think you're meant to fit it with the plastic in and then take it out? Didn't do that. Lip of the seal caught a little bit when the housing first went on but just took it off and straightened it up and went on fine. With my OCD now a bit worried I've balls'd it up. Seal looked completely fine when it went on.
 
Also, how the ****ting crikey do you do the fly wheel bolts up without the tool the fixes the crank shaft from the front?
 
Back
Top