Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. E

    P38A What can kill a battery?

    I need some guidance. Yesterday I was driving around doing chores did a couple of stops to shop without a problem. Went to the local supermarket and spent 10 mins in there came out to a dead battery. Got a jump start, drove it home, took 5 mins and turned it off. Tried it and car would not...
  2. E

    P38A Is this the head gasket?

    The same for the Beru ones I had on hand. Plus I lost one as it dropped into the engine somewhere. no amount of searching could find it.
  3. E

    P38A Is this the head gasket?

    Thanks, it looks like it's the glow plugs as the back two are wet.
  4. E

    P38A Is this the head gasket?

    Hi all, long time no speak. I am looking for your opinion on a problem I have with my Diesel. About a week and a half ago my Rangie suddenly became difficult to start. Lots of cranking until a cylinder or two start to catch then carry on until the revs pick up. I have assumed that the glow...
  5. E

    P38A Autodim Rear View Mirror

    The later auto dim mirror is considerably cheaper on Ebay, thats why I bought one and found out there were two different types of fitting. I have the mirror on hand so thought why not use it if I need to replace the windscreen. Does anyone know if there were any changes to the windscreen?
  6. E

    P38A Front Door handle where does this piece go

    Can someone tell me where part 22 goes in the diagram below? It fell into the door space so did not see where it came from. I do not like it when I have parts left over but it is usually the case!
  7. E

    P38A Autodim Rear View Mirror

    I have a general question regarding the wiring of the autodim rear view mirror. I need to replace my cracked windscreen due to it being MOT time, it currently has the earlier fitting type. I also have a rear view mirror on hand that has the later fitting. If I replace my windscreen with one...
  8. E

    P38A Solved - Outer door handle not working

    Thanks everyone, I have had a good look at it and it is the same part, the cam, as the one that causes the sticky handle problem. Looks like the door handle pin that moves the cam has worn the seat on the cam so the cam does not move enough to open the door.
  9. E

    P38A Solved - Outer door handle not working

    @Datatek Yes it open from the inside. Its the only way I can use the car. The window winding mechanism broke so the door card is already off. I will have a look to see if that rod has come off.
  10. E

    P38A Solved - Outer door handle not working

    I have been through the old posts but don't think this is the same issue. My drivers side door handle has stopped working but operates as normal. I became worse over time where it would take a number of attempts to get it to open the door. Now it just moves but does not cause the latch to unlock.
  11. E

    P38A Does the 2000MY Vehicle have an anti-top-off flap?

    When I get a problem filling up, I pull the nozzle out a little bit and turn it either upside down or at least an angle. I think it is due to fuel hanging around the nozzle causing the shut off to trigger.
  12. E

    P38A Front door glass seperated

    Last night I lowered my drivers side window and the glass has come loose. I have not done anything yet so assume that the glass has come away from the runner. I can hear it operating when trying to raise or lower. I don't recall seeing this issue in any thread before. So any hints and tips...
  13. E

    Other This is being pushed on me by YouTube

    And discuss!
  14. E

    P38A Attaching side steps

    My mom is visiting and she is struggling to get in and out of the P38. I have a set of side steps so think I might put them on while she is here and just want to get this right. Will ordinary bolts and nylocks suffice to hold the side steps in place or do I need something fancy? I looked at...
  15. E

    P38A Removing Headlight wiper arm

    OK thanks will give it a go.
  16. E

    P38A Removing Headlight wiper arm

    Hi all, how does the headlight wiper arm comes off as mine is stuck fast after removing the nut under the cover of the arm? Does it pull straight off or does it unscrew? Don't want to do anything that will break the arm as I usually do.
  17. E

    P38A Tailgate(s) where do they rust?

    Is there any know way to repair a corroded tail gate. I know its an ally skin on a steel frame but wondered if there was a solution.
  18. E

    P38A Front Propshafts for sale on Ebay

    My front propshaft has failed, managed to find the problem before it let go. I am looking for a replacement and ebay sellers are saying that they fit all models. I know that is not true so how can I check that I have the correct part if I buy from one of these scrappers?
  19. E

    P38A Window Switch Pack

    Hi all. a few months ago I cleaned my window switch pack as a window was not moving. All was well after taking off the black switch caps and covering the switch pack in electrical contact cleaner. Now all but one window is not working. Am I missing a step in cleaning the switch pack? The...
  20. E

    P38A Near bakes binding for no obvious reason

    Do you think you overheated your brake fluid given there was a lot of smoke and heat?
Back
Top