Search results

I put a hole in the bell housing of my first disco after I dropped the push rod inside while doing the slave cylinder it was sat just next to the hole and I managed to get it with my finger which saved an afternoon splitting the gearbox. it's probably something similar:)

in a word no

Hello I 100% recommend PRO COMP shox they are amazing I have done 25000 miles on mine. I off road almost weekly in all types off terrain I don't tread lightly and on road the are just as good a mate bought some about a year ago and he swears by them also. try em you will like em:):) PS fit...

check your drivers door seal, the air-con is above passenger footwell with the trans tunnel in between it can't be that. the inlet/outlet from the heater matrix are plastic and again these are on the passenger side behind the block so probably not these the floor behind the pedals can and does...

check the wires on the back of the barrel to make sure you don't have a short.

check the pipes to the heater matrix and the matrix itself

my LAND ROVER is a 200 TURBO DIRECT INJECTION. see not a vw in sight. On top of my engine the sound deading cover states turbo direct injection and in the genuine LR manual the same with no reference to vw. don't believe the hype.

Turbo Direct Injection

Normally when a 200tdi head gasket goes it blows at the back ( between the block and bulkhead ) it sounds a bit like a steam engine and is caused by a build up of carbon you can actually feel it if you place your hand of the back of the block Its happened to me on two seperate Discos both...

If you have a decent mechanical knowledge it is easy check out my pictures it took roughly a day on my drive way and cost £18 for a new gasket. The gaskets have to be the right one I think there is three sizes take your old gasket when you get the new one to make sure you get the correct one. If...

wd40 is a plasticiser so it keeps the inner belt softer and stops squeals.

spray a little bit of wd40 on the belt

If you dont want to buy a new bumper do not use it or put anything on it for recovery it WILL bend like a sheet of paper I know it happened to me using a plate behind the ring thinking I had strengthend it. I looked a proper tit has my bumper folded in two.

I always put about 10mm above max. Gives me piece of mind when at silly angles and its never caused any probs I've done over 35000 in the last two and a bit years.

youve got a bad earth

I've done 35000 miles trouble free in just over two years and it doesn't miss a beat regular tlc is all it asks for.:)

On a private road my pulls 105 on the flat with the boost wound up and fuel pump tweeked on insa turbo dakars it is VERY loud. it also corners like it shouldn't on PRO comp shocks leaving a lot of euroboxes stunned.

do you mean the 2.0 mpi engine ? if they both have the LT77s gearbox it may fit>

air flow meter ?

check the rear A frame ball joint and rear trailing bushes both simple jobs but the A frame takes a lot of time:)