Search results

Hi I have recently rebiuld my series 3 gearbox and installed it but when i try and put the gearbox in rear wheel drive it goes in to neutral. In 4 wheel drive high and low it is fine. When i press the yellow knod down it takes it out of 4 whell drive but then goes int ot neutral. Has any body...

Help required. Does any body have a series 3 diesel steering column lock with the the pull cable stop for sale as mine has all come to bits and there seems to be no way to get it back together. Thanks for any help.

Hi could somebody help me tell if I have got range rover diffs or not. I did purchase these a couple of years ago and was told they were ranger rover diffs I am just getting round to fitting them now. Having swapped the front diff and comparing the 2 I can not see any obvious difference...

Hi can some body help. I have recently changed the balast resistor for a new one and replaced the glow plugs with new ones but since then my glow plug light in the dash has been very bright indicating a dead short well so the manual says. I have cleaned all terminals up changed the glow plugs...

does any body know if discovery wheels will fit a series 3

Does any body know the outside diameter and the thickness of the top bearing for a series 3 steering column.

Just replaced brake shoe and wheel rotates fine forwards but in reverse it grabs and locks the drum. I have checked every thing is assembled correctly. Just wondering if any body else has experienced this problem and how they over come it.

can any body shed some light on the problem iam having. I have fitted a s11 engine, changed the fly wheel to a s111 flywheel, s111 clutch from the original engine a s111 but this does not work. The gearbox is a s111 6 cylinder with the s111 bell housing. When pressing the clutch pedal down...

Does any body know what the minimum thickness a series 2a fly wheel can be skimmed down to. This is the flywheel with the starter ring gear as part of the fly wheel and the 2 locating dowels.

Hi after some advice I have a 2 1/4 diesel it seems to smoke black smoke with any acelleration once at a crusing speed smoke stops but if you put your foot down again it smokes black smoke again. When going up hills or when the engine seems to be under strain it seems to smoke. The engine does...

HI can any body point me in the right direction. I have recently changed the head gasket also had the head skimmed but not pressures tested. Once the engine was started it seemed to get very hot I checked the radiator hoses the top was very hot the bottom hose was stone cold. I had fitted a new...

I have just stripped the head of my landrover because head gasket has gone. one of the swirl chambers has come out and the other three have a slight wobble. I can not find any info on what to do if they come out,and how they are held in place. should I need to replace it does ay one know the...

Hi can anybody help with some information. I have a series 3 2 1/4 diesel that has suddenly stopped running over two short journeys. Firstly it became hard to start and there seemed to be no power. Firstly I thought is was a fuel problem I have changed the fuel filter and this did have a...