Search results

Hi Thanks for your replies. I've had a look at the user manual but it doesn't really help. Definitely turns faster when wired one way. I bought privately and the control was missing and I'm trying to use a generic control so the wire colours aren't necessarily the same. Also trying to wire in...

Hi I'm fitting a superwinch X0 to my series and trying to sort out the wiring as the remotes where missing , the coulour schemes seem all mixted but it seems wiing one way the motor turns slow and the other the motor turns faster. Would I be right in thinking it shiould be slow pulling in that...

Great , hope you find them I'll wait to hear and let me know how much you want for them if you do find them . I fitted range rover diffs to a military S11a that was fitted with a Perkins 4203 , so a really torque but slow reving engine the range rover diffs really made a differance gearing up...

Ok never mind . Thanks for looking :) Let me know if they turn up .

Great I'll wait to hear back from you. I'm away from home as well till Monday . Thanks Paul

Hi I'm in Hereford , but I could possibly arrange shipping . Where are you ?

HI Not sure where to post this one so I hope its ok here ? I'm looking for a pair of Range Rover diffs for my series landrover , to up the gearing a bit . I assume it has to be the older classic Range Rover so if anyone is scrapping one let me know ! Thanks tetatate

Hi I asked this question some time ago but didn't get a lot of response so I'm trying again . I have a series 3 with an early Daihatsu fourtrax 2.5. I'm thinking to replace with a later Daihatsu 2.8 TD . Doese anyone know if this is straight forward is the 2.8 basically the same engine as the...

Hi When I swapped the pair of shoes over then the pulling swaps over too so on the face of it ,it's the shoes but , their squeaky clean ! I guess I'll replace the drums and shoes. Good to hear you have found non-genuine shoes and drums OK , I too have had bad experiences with non-genuine wheel...

Yes I'm thinking about that , but not totally convinced it is the shoes / drums otherwise the swapping should work , shouldn't it ? Also the shoes were new last year , and show no signs of bad contamination or burning I have had a load of trouble in the past with patent parts not fitting...

I totally cleaned up what seemed to be the slippy shoes , boiled with detergent so they really are squeaky clean. still they seem to be slipping , that is its pulling to the other side. I then split the pairs one from each side on each wheel. . assuming if there is one bad set them this...

Well the shoes don't seem greasy or contaminated and the there's no oil etc inside the drum. Could some subtle invisible contamination be seeping out of the shoes and making them slippy ? Seems unlike, I'm going to try degreasing the shoes , I'd usually use petrol but maybe I'll try a method...

Hi:) So some change I've managed to make it pull to the other side ! This was after swapping the shoes from left wheel to right . So an obvious assumption is that its slippy shoes , but all four of the shoes look Ok , and I'vedeglazed with sand paper each time Could there be some...

Hi Thanks for your postings everyone . Heres were I am with It . I checked the back brakes and all seems fine there , cleaned them up bled the right hand side ( as pulling to the left ) adjusted back up carefully. Still have the front drums swapped over took it for a run and it is better but...

Ok ,so this is what I did this morning . Made sure I had good hydraulic pressure to drivers side front ( right side of vehicle ) Adjusted front brakes and tried again - result - pulling left. Adjusted left side back so , totally off - would expect then that it pulls to the right but...

Ok I'll swap over the drums and see what happens:)

I have new last year original cylinders. the shoes may not be all the same brand and new last year. I may start swapping stuff around though not convinced it will help. also though not badly scored there are some shallow grooves on the drums and the shoes bed into their particular drum . Paul

Drums aren't badly scared and theres no grease etc. Maybe I'll try swapping the shoes , but only because I'm run out of ideas and can't think what else to do

:doh:Hi Thanks for the replies. theres no grabbing the shoes are chamfered no fluid or grease on the shoes. and they are bedded in . I have bled up pretty well , and even back bled under pressure on the right side, where the problem should be as its pulling to the left. I have an feeling the...

Hi I'm really lost with the brakes pulling on my series III 88 . the brakes are the two cylinder type. With dual vacuum assisted master cylinder last year I had the same problem of pulling to one side , I fitted new shoes, and cylinders to the front and back , replaced various pipes just in...