Search results

Thank you

Thanks I'll have a look at the weekend you don't have any photos by any chance

On the top part of the bulkhead I have the high lift and I also have fitted a cubby box in the middle with a radio on the back of it. How have you run the airlines

Morning all hope you are all having a good Mother's Day. I have brought a ARB Compressor not that I'm aloud to fit it today but am thinking of were where to mount it. I can't put it in the batter box because I have two battery's there. Would behind the front seats of my 90 work or under the...

I'm sure you have though of this but I fitted a kenlow fan and it has a thermostat on it so you can protect your engine. Mine doesn't comes on it the winter unless stuck in traffic. It has a control on it so you can set it up as you want.

Thanks James I'll see if I can find the part number for them and give them a try

The gear box is a Santana LT85 I know it's a differnt size as I got the complete carpet set from exmoor trim and it won't fit due to the tunnel being bigger

Evening all hope all are well. I am in need of front floor mats for my V8 1988 90 I know the gear box tunnel is a different size so exmoor tim carpet sets don't fit. I have looked up the Land Rover part number RTC8098AB but has any one fitted them in a V8 or do you have any part number that...

I went for a Marsland very happy with it all fitted as it should.

I had a small patch and found it cheaper to pay a bloke to Tig weld it as by the time I changed the gas, tourch liner and brought the aluminium wire it was cheaper to just pay him. Tig welding is easier to control they normally use a foot pedal to control the power so don't endup blowing holes...

I've not got one on mine it's an 1988 90

I would go stone chip to seal it then a coat of black hammerite under boady seal as it's harder wearing the the waxoyl

As you have put the mordant solution on it you have stripped the galvanised finish off the out side of the chassis. So the specialist Metal primer may not stay on sounds strange but give it a scratch with your nail and if it stays on its ok if it comes off you will need to jet wash it off and...

Thanks for the info do you know were I can get the kit from

Hi ya I am thinking of putting a snorkel on my 1988 3.5 v8 twin carb 90. Is it a bad idea if not I know I need to extend my axle breather pipes and gearbox. Is there anything else I should do. Thanks for taking the time to read this.

Hi ya I want to mount amber flashing lights to the roof or my 90. The plan is to fix them to a roof bar with spots I have seen lots of led light bars some chap and some not some cheap. Any recommendation would be a big help I don't want to buy any rubbish .

Thanks your right they r drums I'll check them out tomorrow

Hi all checked the hoses they are still ok any one elce think of any thing to check.

Thanks Dan I will check that I did replace them and up grade them to Terrafirma ones.

Morning all I rebuilt my 1988 90 two years ago and the brake peddle has lots of travel in it before it starts to work. The garage I get the mot done at thinks its to much and I tend to agree. I have had them bleed the brakes and there is no improvement. I have also checked all the brakes...