Search results

I used a Dremel to make a usable slot then used a replacement cap as suggested above. Ian

My P38 has started draining water from the N/S sill, it appears to be from a drain hole below the rear door. I have seen this twice today after parking the car & I suspect it may be related to the aircon vent. I get a small puddle under the drivers side vent, I don't get one under the passenger...

Cost around £15 IIRC, mine came from Rockingham Landrovers but I think they got it from LR anyway. Ian

Just ordered mine, didn't work from a Mac so had to wait until I was on work Windoze machine. Ian

Thanks, I've just checked and it starts now, letting it charge some more. Ian

I've been away for a couple of weeks, went to start my P38 4.6 this evening and it doesn't turn over and I get a gearbox fault message. I've done some searching and this seems to be caused by voltage drop so I've got the battery on charge. My question is whether this fault will just clear itself...

I'm up for one too please. Ian

Thanks, mine aren't welded on however, they are connected by flexible pipes, hence the different location. Ian

Yes, the TP24 does look similar, on my car the tailpipes are connected to the centre box by flexible pipes, it's the end on one of these pipes that has corroded so a replacement tail pipe alone won't help. I really need to identify the full system I suppose. Ian

Can anyone identify which exhaust system this tailpipe belongs to, I need to replace one of mine if possible: Ian

A very neat job well done Ian

Yes please, can you also include tips on removing the trim panels. Ian

You need to submit a form V888 and a fiver, you can get the form here: Full list of downloadable forms Ian

My rocker covers are in a mess so I bought a pair of eBay, they were rough too so I sent them for powder coating. I picked them up today and the LH cover is different to the one I have on my car, if I fit the new cover the oil filler will be next to the bulkhead/firewall, I think there will be...

Just a query, would silicon grease not be just as good for this? I used to do a lot of diving and used silicon grease for electrical connections for lighting units, this kept the moisture out and seemed to work very well. Ian

It sometimes pays to haggle with RB, I got £30 off the cost of a new radiator for my P38 when I pointed out I could get it cheaper elsewhere, they didn't match the best price but came a lot closer. Ian

In the past I've just asked a garage or a machine shop with a press to push bushes (not LR ones mind) in for me, I've never paid more than the price of a couple of pints either. Ian

Sorted - must remember to not be too gentle :) Ian

Thanks Ray, your setup sounds like the spare pair of covers I've bought, the ones on my car don't seem to have the "trees". I'll get them cleaned up at the weekend and buy a couple of new trees so I can swap them over. Ian

I have a 4.6 HSE, the RH rocker cover has a stub pipe which connects to the plenum by a length of rubber hose. The hose was looking ropey so I swapped it out to find that the stub pipe is blocked solid, I can't even scrape the crud out. I bought a S/H pair of rocker covers so I could clean them...