Search results

Hi All, Approx 1 year ago i replaced my Fuel Pressure Regulator for a brand new one. I have noticed a decrease in MPG on my car and i at first suspected this culprit. As i looked underneath it did look a little damp around the starter motor, however after 20mins of watching the small...

Hi All, I have recently developed a rather strange noise when the disco is on tickover or accelerating. It is very much like a cricket sound on/off/on/off and the more revs you give the faster it gets. It is worse when the car is cold too. Its not a constant squeel. Does anyone have any...

Hi, Just a quick one, When purchasing a nanocom do you have to buy one specific to the vehicle model? ie defender/discover or do all nanocoms have the option to cover both? Regards

Hi All, Is the TD5 Discovery Clutch change an easy job? - Obviously the gearbox will need removing, im assuming it will need completely removing therefore requiring the vehicle to be on a lift? Anyone done any or know of any step by steps? Searched the WWW our greatest friend but not found...

Hi All, This has probably been covered before but i cant seem to find anything so here goes. Is there any diagnostic machine out there that will fullfill the requirements of the TD5, including the extra modules to identify the cause of the 3 amigo's etc and also be suitable for other model...

Hi All, I changed my R380 gearbox oil this weekend due to 2nd being a little stiff to get into gear, thought i should treat it to a spot of new oil! Its now more difficult to get in all the gears!!!!! (until warmed) Surely this shouldnt be the case should it?

Rightio Everyone, I have a copy of the T4 Software :) Now, the question is, how do you get it to work... Does anyone already have it and have it working?

Hello All, I am hoping some of you can shed some light on this simple job that has took me two days so far! The pinion is not coming out, once i have taken the propshaft, off i am met with the peg(Pinion) that covers the nut holding the flange on. I cant get this bloody thing out...

Hi All, I have a leaking A Post on the drivers side, I have NO idea how or why its leaking. If i peer up the side of the dashboard on the A Post i find that there is a small spot weld and its dripping through there. I have taken the wing off and can see no place of entry into the A Post, The...

I have carried out numerous searches on this problem and its starting to get on my nerves a little now to the point where i think oh f&%$ it, it'l be rate, im getting rid in three years! Anyway, I have previously had a rather bad leak from the Windscreen top seal, this was fixed about August...

Hiya Everyone, Does anyone know of a step by step guide for carrying out the oil change on the R380 Gearbox? Rgds MArk

Hi All, Im causing some right caos on this site asking questions all the time but i'm planning on doing all the repairs on my Disco at once! I mentioned on another thread that i had oil mist all over my Alternator etc, I have been trying to trace this with little luck, however on the...

Good Evening All, I have just been underneath my Disco TD5 and looked up! As i looked up into the engine bay i could see my Alternator covered (Dripping) in Oil! Now, I couldnt see where it was coming from underneath as i was layed in my back, I looked fro above and couldnt see any tell tale...

I have a problem! I have just noticed the rear footwells around the B Pillar's is wet! - Its the first time i have noticed this but we have had some heavy rain over the last couple fo days. What are the likely places for it to be coming in? If i seal up the sunroofs with some Silicone from...

Hello again everyone! - has anyone found an easy way or location to put wires through from the engine bay into the vehicle. I am just in the process of fitting a little device for the light theiving scumbags!

Hi All, I am going to trust your judgement - If I dare!! Does anyone know of a trustworthy, independant Land Rover specialist in South Yorkshire, preferably the Rotherham area.

Hello All, My 2003 Discovery has decided it wants to do 3 chimes when i start it up every now and again. The 3 chimes is normally to do with ABS, however i have no warning lights on.. Any ideas?