Search results

Insurance have insisted on taking it to Norwich just to be buggers! Did look before it went but no show!!:mad:

Hi all, Anyone know where I can get an FP ignition key? Mine was in my discovery which burst into flames last week! :mad:

Hi all, Any one know best way to fit 2 lpg tanks ie. how to plumb them together? have bought 2 tanks from a disco and they both have multi valves fitted but the pipes have all been cut off. Any help appreciated.

Does anyone know which of the two feed wires that feed the disy which one is live? the Red or Blue?

:blabla: hi everyone, anyone know where the low tension Blue and red wires come from that feed the distributor on a 3.9 dico, used to be a disco but that was when it actualy moved! Please help. Steve

Thanks for that, the cap on this one is a good snug fit in fact I had to strugle to get it off but does seem to fit well. Will let you know once I get it started. You recon it will be OK to drive like that then?

:welcome2:Hi all, well it started misfiring so whent to remove rotor arm and the whole shaft lifted up about 1/2" before arm came off! Told its a common problem, anyway to cut a long story short I decided to invest in a new disy from simons bbc Arrive this morning put it in but won't start:mad...

hi all,:welcome2: has any one out there got a rear sensor they don't need? I'm desperate and just can't aford a new one!:mad: Come on make me:blabla:lol Thanks Steve

Hi, I have a 98 disco 1 The ABS light is on all the time, it started when I did some hard brakeing on ice earlier this summer lol!!! Anyway I have removed 3 wheel sensors, cleaned them and put them back. Found one wheel bearing was a little loose so tightend and greased and cured. Last wheel...

Hi, mine connects to the adapter between the carb and manifold. Alternatively you can get a K &N breather filter which just goes on the end of the pipe.:)

:welcome2: Hi all, have converted my 1958 S11 from dynamo to alternator by leaving the old regulator in place and conecting the necessary wires together. Everything works fine BUT as there is only one fuse on the S11 does anyone know where to take the temp guage live from? Thanks all

Thanks 2 all, will try them. Just fitting a new clutch master cylinder mine packed up on the middle of a bridge! Had to get the rac out took over 3.5 hrs to get home and I was only 2 miles away! Said the landy was too heavy for them and had to get a recovery lorry out! That's landies for you.

Hi guys, Thanks 4 the quick reply So the petrol 2.25 will accept the diesel housings without any mods ? if so has anyone got one going spare?

:welcome2: Do es anyone know how to convert my series 11 oil filter housing to a screw on type?:mad:

:blabla: Thanks Dave I'll give it a go.

Hi all, does anyone have any experiance of changing the breathing system so that the engine breathergoes into the air inlet after the mass instead of before it? I'm told this mod would make it run smother, quiter and be more efficent?????

thanks 4 that, but soes it matter which way round the wires go on the instrument?

As everyone has said it all depends on what you use it for! I've just fitted paras to my 58 lwb s2 I put the front ones on 1st and was well pleased but now I've done the back I'm not so happy, the ride is just so bouncy.

Have you checked the fuses? if so check you have an earth conection at the lights. Also check the earth from the battery to the body and that the alternator is also earthing properly. Use a meter on homs setting to check continuety. Good luck!

:doh: Hi all , Has any one fitted a water temp gage to a series2? How do you wire it, I've got a sensor in the front of the haed but nothing else any help appreciated.