Search results

Could be a starter motor problem, had a bit of the same issue, just removed mine cleaned all connections, earth was loose, then refitted and it fired up straight away, not had a problem since...

Its the plastic strips that run along the bottom of the inner door sills, cant seem to find any for disco 1

Hi folks, Trying to hunt down some inner door scuff sills for the disco 1, but having nee luck, can anyone help. Cheers.

Had one for a few years now and the engine, underneath still in tip top, sure it still has the normal disco problems. One thing I don't get, it too of range and has double sun roofs, but why its got air con . :crazy

I got my latch springs from Disco-compatible-parts.com & you get fitting instructions too. ;)

Need to replace both full length brake lines on the n/s of my 1998 disco 1, is there a type of line were you dont have to use a pipe bending tool. Any advice would be welcome. Cheers. :p

Have a look into the import discos, theres know rot on these discos and you get more spec for your cash and low mileage compared to the same year as an uk spec..

Well I think its test & trial what ever you feel comfie with, I've tried all the different pressures ( on the good year ) and i'm very happy running all 4 on 34psi nice ride even wear and towing a caravan spot on and the breaking is good too..

Tweets, had the same prob with my disco v reg, the pipes will be spilt at the ends, just replaced mine with washer clear pipe, its a lot cheaper and stronger, with no probs, just warm the ends in hot water and they slip on nee bother. If your not to sure this is were they go. One end comes out...

Hello all, I'm after the work shop manual for a Discovery 1 1999 300tdi county, all help would be welcome.. Cheers :D

Rrrrr your so kind fellas, haware I'm a Geordie, wear d ya think a tortel got its shell from ??

Had that problem with my old 94 disco, ordered a dash repair kit cost about £65, took me a couple of hours to fit, can be a bit fiddley in places, helpfill tip us a bit of sharpened metal rod bend it too 45o angel, heat the end and use it for making a hole in the hard plastic part of the dash...

Hi to all the Landy lover out there on this site, it great to apart of this forum, looking forward to reading the posts and being of any help myself..:D