Search results

Does anyone know where I could get a 1 full harness. 2 srs harness with it's original ECU. 3abs ECU. have no part numbers in a bit of trouble.

Does anyone have a tool lrt-41-005. It's for the input shaft to set the pre load. Any help would be appreciated.£££££.

Does anyone know where to purchase a non collapsing spacer for t/b

Anyone have a r380 suffix j type55a manuel gearbox to fit onto a disco 300tdi for sale

From automatic to Manuel. Does anyone know which model gearbox I should use for this conversion.i know it's a r380. And with having 31inch tyres on should I change the ratio in the t/box.

No gearbox on been renewing rear crank seal. Would it be ok to start and let tick over to check seal ok.dont fancy it leaking.

Swapping automatic box for r380 box.would my transfer box be ok to use or would I need another. If so what t- box would I need what ratio. What has other people used. Cheers.

Here's a one for the experts.n reg import. On changing auto box for Manuel. Renewed rear crank seal.brand new fly wheel holes all line up but a can't get it to fit crank.not slagging any one off so am not after that.but is the fly wheel to be that tight don't fancy damaging it.is it me or is it...

Automatic box changed to Manuel r380 box. Do I need to change gearbox cross member or not.!

Has anyone had problems with putting new fly wheel on. Removed automatic box for Manuel. The tolerance on the crank and center of fly wheel are really close.

Fitting a new rear crank seal disco 300tdi. Does most people only use a gasget.or rtv.or both. Don't want to f up. Cheers

Changing auto box to Manuel.there is a flat casing on the back of the block that join's the box. Does anyone know if I need to replace it or leave it.because if I have to replace the bell housing surely I would need to replace it. Also what's people's thoughts on the transfer box.should I change...

Going to remove automatic box replace it with Manuel r380 box. Do anyone know if my gearbox cross member would be ok. And would the bell housing need replacing.?

After a lot of problems with the wiring harness. Does anyone know (I know which relays To look at) If I take out the relay's and put a separate fused wire to operate fog and the rear wiper.

Been trying to find the wiring instructions for the fourby egr gauge tried Google. Does anyone know.

Does anyone have a fourby wiring diagram for a usb clock kit.i need to put mine in and can't find diagram. If so any chance of a picture of it.

Would I be able to remove the air box altogether.so it comes from the snorkel to the turbo.would it run ok. 300tdi.

I have no watts linkage or rear arms.they were removed. Just wondering what other people think. Leaving them on does it interfea with the lift on the vehicle.

Finally sorted those ffffff fuses.on the drivers wing when I routed the cables along and to the headlights. There were 4thin black wires.stupid me thinking they were earth wire's. Two were live.they go through bulkhead and into a small plastic block full of thin black wires. So be careful don't...

Still got this problem with the satellite fuse holder.there is two fuses that are at fault.second one down 15amp.soon as you switch the ignition on pop goes the fuse. The bottom one 25amp(think)no ignition and nothing switched on.try and put a fuse in and pop goes the fuse. Been on a while now...