Search results

Hi I'm having problems to remove the bolts for ARB, will try with bolt extractors. Can I replace the original ones (FS108207L) with a M8 13mm head rated 10.9 bolt? The others are expensive to buy over here. Thank you in advance

Hi After changing inlet gasket, water pump and timing belt my radiator decided to give up and start leaking. Not much, mostly weeping but have to do something about it and K seal is not recommended. Have I understood it correct that I have to remove front bumper and then it's easy accessible...

Hello, I have started changing the timing belt on a FL1 1.8. After struggling with the flywheel cover I now have the inner bolt for the engine mounting left. (One of the two close to the engine block) The extension rod start to twist so I’m afraid I will break something. I’m away atm so...

Hi folks, Well, after destroying a couple of the clips (DCE100560) for the side finishers I better ask how to remove the upper finisher? Don't want to destroy it and it isn't obvious for me on how to do... Should it be lifted or slided, to my defence it is difficult to see due to a lot of...

Hello, A really stupid question.. While doing some welding on my Freelander 1 I removed the inner wheel arches and when I put them back I noticed there were no protection for the edge. Is CLB100160 (No 5 in picture) the only protection for the arch? Do you guys know the approx length och...

Hello Sorry for this, there are already numerous posts regarding window regulator. In my car the previous owner fitted an aftermarket regulator/motor. If I need a new one I have to buy both or the motor won't fit, any advice of a good enough brand? The problem I have with my current setup is...

Hello, I have problem with water in the small compartment illustrated by the photo. I suspected the fuel filler and tried to seal around it and especially where two arrows point. Still after a heavy rain water enters even if I don't drive the car, so my question is if there shouldn't be sealant...

Hi, I changed oil in my gearbox (Freelander -04 1.8 manual). I had problem to find MTF94 so bought Liqui Moly 75W80 instead. Changing gears works fine but I now get weird errors, HDC (C1151), I expect electrical malfunction in reverse/1st gear or brake switch. Maybe just bad coincidence it all...

Hi, I gonna change the bearings for the prop shaft and wonder if it’s a good idea to put the VCU in the fridge to make it easier to fit the bearings? kind regards Chris

Hi I'm a new member and a Freelander for the last few days and have a couple of questions about sensors on a Freelander 1 -04. I scanned it with a OBD reader I got an error message P0480 and some temperature values I don't understand. I left the car over night so expected all reading to be...

Hi, Just like to introduce myself. I just bought a Freelander 1 -04 1.8 and live in Sweden. I own a Triumph Spitfire for years so used to english cars and their mechanics. With this Freelander I realised the challenges introduced with computers and electronics.... Cheers, Christopher