Search results

Just sold my 1998 P38 4.0 SE for £3000 Thanks to everyone who helped me with issues and the HSE upgrade.

Why negative to body rather than battery? Have i been doing this wrong a lot? I presumed the battery would be best?

Good luck with your new car! You can download it here: land_rover service manual Its very helpful!

Is that as simply as it sounds? Its a Lowline diesel, so if he was to get hold of a working one toreplace his, is there any programming that needs to be done to tell it that it is in a new car? Thank you for the help

Thanks for your reply. We had a look at the earths yesterday thinking that they would be the problem, and they all look good. We also took the top of the BeCM off and found it was RL7 that is clicking in and out. Thats as far as we got though! Not really sure where to go from here now!

This problem is occuring on my friends P reg DSE. Sometimes everything works, but whist driving a clicking noise is heard (similar to the noise a relay makes) from the BeCM, and then he looses most of his electrics, including the climate control, radio, and wipers. The dash computer stays...

Nice pictures!! Mine has ploughed on through water deeper than this, mainly in the High Easter ford pictured earlier, without any problems. I just put her into high and go through gently and have made it to the other side so far! I have had the water come up over the headlights before too...

I thought that was Good Easter. I went through there the other day and mine held up OK!

Just out of interest, where was this photo taken??

Is it possible to T off off of the air compressor tank to run a seperate air supply that a standard air line can be attached to for pumping up tyres etc? I saw a lorry the other day that had a air line connection coming off of one of its air tanks and wondered if i could do the same?! Matthew

i think the correct term is rare as rocking horse sh*t

No, its still refusing to budge. Ive given it a good clump, but it still feels fixed. Once those clips are free, is the bumper meant to pull off backwards, or are sides meant to be moved away from the body, and then pulled backwards?

Thanks for the response. I'll go and give all of that a try! Glad that i havent gone mad and left a bolt unnoticed!

I've become a bit stuck while trying to remove the rear bumper off my p38. Ive done everything i believe to be right so far... which includes: Removing the 2 bolts either side of the tow bar holding the bumper to the chassis. Removed the wheel arch extensions from the chassis. Released the 2...

I get this a little bit too sometimes, but its not loud and feels like a tapping under my feet. I had a look whats there and all i thought it could be was the loose exhaust heat shield vibrating in the wind? Is that possible?

Sounds like its worth a shot for a free fix! I'll have a look when i get a chance!

Right, i believed it to be the rear boot seal, but now i have a live worm swimming in about an inch of water in the boot! Is it still likely to be the boot seal if little animals are getting in too!?!

Sounds good! So is this the seal that goes all around the upper and lower tailgate?

I've added the front 2 footwell lights, the rear cubby box/footwell light, the rear 2 puddle lights (had the front 2 already fitted) and the rear 2 map reading lights. The looms were all ready there in my 98 SE. As for the load space, mine already has a light, but it is pretty poor for such a...

I keep being tempted to buy that off ebay too. Still unsure how obvious it will look though.