Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. Camshaft

    Gearboxes?????

    Does a discovery R380 gearbox fit into a Defender TD5? or is the bell housing and shaft too short? Thanks in advance!!!
  2. Camshaft

    TD5 Knock.

    Hello again i have a 2000 TD5 90 and it has recently started to make a major knocking noise when at full lock at really low speed (when parking) and have no idea what it could be ive been underneath when it does it but i cant see anything obvious any ideas???:confused:
  3. Camshaft

    TD5 Oil Leak

    Hello ive had a oil leak for months now and its like niagra falls. ive got underneath t and cant see where its coming from it seems to be running down the Drivers side of the block but seems to be all the up th eside of the block i was just wondering if anyone could think what it could possibly...
  4. Camshaft

    Gearbox Issues!

    Hello i have a 110 td5 110 2001 plate, it has real problems with the gear selector as its so sloppy and feels like its in neutral when in gear. i struggle to get it in 5th or reverse ive taken the main stick off and the ball joint completely out and no wear found as of yet although the locating...
  5. Camshaft

    TD5 Overheat

    Hello I have a 2000 reg TD5 09 which has been remapped i have recently noticed that if im on a motorway at 60 mph all is well but if i do 70 it slowly starts overheating and the needle creeps up to the red. does anyone have any ideas? Also when doing around 70 in every ten minutes it makes a...
  6. Camshaft

    TD5 Oil Rotor Filter

    Hello i have a 2000 defender td5 and have noticed when i turn the engine off the Oil Rotor Filter continues to spin and makes a winding noise, whats wrong is it just worn or is it the oil? its also been remapped. Cheers :confused:
  7. Camshaft

    Help!!!

    Hello i have a discovery td5 with seven seats and i am wanting to remove the loadspace two seats to replace with the side cubby boxes, does anyone know how to remove them? Thanks in advance, Paul
  8. Camshaft

    Air sunspension!

    Hello after checking our sunspension on our discovery we have found that the compressor has burnt out, has anyone had there ECU programmed to remove the air sunspension function? how much does this cost? Cheers Joe:)
  9. Camshaft

    Air sunspension!

    Hello i have just taken a close look at the air sunspension system on my discovery TD5 and it would appear that the compressor to raise the sunspension isn't working at all, i have checked the fuses and it is blowing the 30 Amp fuse straight away, does anyone have any ideas....HELP! thank you in...
  10. Camshaft

    DISCO TD5 Manual

    Hello i was wondering if anyone has a link to a manual for a td5 disco online? preferably free:) Thanks Joe
  11. Camshaft

    Disco air sunspension

    Hello i have just bought a td5 disco 51 plate and it has air sunspension, it seems to be sitting a bit low on the back end constantly and i cant seem to adjust it, any ideas???? Thanks in advance everyone Joe :)
  12. Camshaft

    Clutch, HELP!!!!!!

    Hello, i have just purchased a TD5 diso with a clutch fault, the clutch only seems to bite at the very bottom, this is also making all gears hard to engage, i have bled the system and there was a slight improvement, i then swapped the slave cylinder and it is as bad as it was in the first place...
  13. Camshaft

    Tyre Nightmare

    I have been running Insa turbo special tracks 265/75R16 on my 90 and they make alot of noise and make it handle terrible. i am thinking of goin for BF Goodrich AT or General Grabbers AT2. But i am unsure about what size as it is lifted 2'' and has spacers i want it to look decent but not handly...
  14. Camshaft

    Props

    Hello are the defender 300 props the same length as a 2.5 N/A 90 props? If not which are longer which is shorter????? Joe:confused:
  15. Camshaft

    EGR control unit?????????

    Hello weve just purchased a 300 TDI engine to put in our early 90 and it is fiited with a EGR valve and therefore a EGR valve control unit. will the engine run without this being plugged in? whats the actual point of an EGR valve. I know its a exhaust recirculation valve but what is its use...
  16. Camshaft

    200 Tdi!

    Hello im breaking a discovery 200 TDI engine previously fitted to a 90 all parts available also had a recent new turbo all auxcillaries available Reply to this message if interested. Many thanks Paul
  17. Camshaft

    200 Tdi!!

    Hello im breaking a discovery 200 tdi engine, everything in terms of the engine available. Recent new turbo available and all auxcillaries. Reply to this message if interested. Cheers Paul
  18. Camshaft

    300tdi into N/A 90!

    could anyone possibly give us some dimensions of where there engine mounts are on the chassis on a 300 tdi defender. Also the dimensions of the gearbox mounts would be a massive help. some pictures od the mountings would be a great help. Cheers Joe:) P.S Any problems that anyone have...
  19. Camshaft

    Wheel Spacers!!?!?!

    Hi we have bought some Insa Turbo Special Track Tyres 265/75/R16 for our freestyle rims and they catch the radius arms at full lock. Will 30mm wheel spacers stop this? we have wound out the steering stops but the turning circle is too poor. With wheel spacers will the tyres catch anything else...
  20. Camshaft

    Injector??

    Ever since rebuilding our 200tdi discovery engine fitted to a defender, its nevver ran correctly a bit low on power and rough idling. we loosened the injector pipes on each injector whilst it was running and noticed the first injector makes no difference to the running of the engine if loosened...
Back
Top