Search results

Yes it was too long 8n this case but I put a washer on it and sorted the problem put finally.

Thanks for the information. I may just look for a scrap hub assembly in this case. Tried to put a picture on doing as you said but says not enough memory. Thanks again though.

I recently managed to snap a a stud the wheel goes on and and wondered if it's possible to get a new one and thread back in? Also how do you add pictures on here?? Would of uploaded :/

Sorted now mate. Found something on here about the switch under the brake pedal and it he lights went OFF all of a sudden!! Made up though just if it happens again I will get a new switch. Thanks for the reply anyways! Much appreciated

New to finding my way around mate. But thanks again!!

Been trying to attach a photo but won't upload for some reason. I have two lights on dash one is YELLOW (a car going up a slope) and the other is YELLOW too TC traction control. I changed the gear box fluid put plug back on and connections now shows those to lights. I also changed the reverse...

Genius thanks mate all sorted!! Phew!!

Bloody genius!!!! Thanks mate... all sorted!!!

Excellent post!!! Used this changed the switch BUT the lights STAY on with ignition on (engine not running) very confused!! Any suggestions please??

Hi all just fitted new swit h for reverse light. New switch works as bulbs illuminated but they STAY ON! ANY advice would be really helpful.

Freelander 1 2004 1.8 petrol

Fitted new switch and lights work but they STAY ON :( Any suggestions?

I have just fitted a new reverse switch and I turned the ignition on (Not in gear) and the reverse lights are stuck on! Any suggestions welcome. Thanks.

Hi. I ch3cked the fuse and there's 12v to the end of the wire that connects to the switch so just waiting on part and hopefully will be fixed. I bought 2 litres of gear fluid too as it ****ed out when I took the old switch out. Thanks for the reply.

Ok just tested the terminals end of the wire to switch there's continuity and 12v. I was informed if the terminals complete the circuit the lights would go on without the switch... NOTHING. Any suggestions people. I have pre ordered a new switch anyways hope it solves it.

Hi. I have a freelander 1 2004 1.8 manual. I am replacing the reverse switch located on the bottom of the gear box. Oil poured out the other day so I am assuming that's the gear box oil and drain plug? I have bought a new switch and new oil MTF94 (2 litres). I found the filler plug removing the...

New tank then and bleed. Thanks again and for staying the cracks not an obvious thing one would look below and wouldn't think on the logic of evaporation through them. This could explain it! Your experience shows. ;)

I have noticed a few scratches there!

Thanks will do that I seen some instructions on here somewhere. Grateful for your feedback I think that's the right option!

Gotcha!! Just thought cause it's so hot it was evaporating in the reservoir :/ obviously needs investigating. Just to pick you brains, how often should (IF NEEDS BE, TYPICALLY) could you expect this? Also I have seen some videos where they apply coolant.