Search results

Been chasing EP90 leak from the felt washer on rear hubs (NAS 88" series 2a 1969) and have heard many different approaches to replacing these with a fresh set - any advise for the best chance of a leak free seal? Have heard to soak the new felt washers in oil to expand them up Have heard to...

Greetings We have some EP90 dripping out the rear axle dust cap, plan to check the breathers and clean / replace as needed. Question is, these seem to be a press fit and new ones are very tight. Any tricks for recommendations on best way to remove old stuck ones? And best way to install the...

Greetings; Planning to refresh the pedal springs soon (69 Series 2a NAS), have some parts on order. Two questions looking for advice on: 1 - for the accelerator pedal linkage, what lube is best? oil, grease or WD40 spray? 2 - is it possible to swap out the brake pedal springs from the pedal...

Greetings - (Series 2A 88 NAS 1969) Noted that when the tank got over filled, gas leaked from the top seam of the tank and under the truck perhaps 0.5 gal. I guess it did that until the gas in the filler drained down enough below the seam.... I think the vent in a closed system, so I dont...

I have been chasing some leaks now that it is raining again in California and the rail channel under the hood along the bulk head seems to dump its water inside vs a clear diversion to the ground. If that channel was a tad longer, water would not drop between the clutch and brake pedal boxes or...

Greetings - New series owner - basic question - we wanted to pop off the breather to give it a clean, thought it was a press fit, and did not want to break anything, it seems well attached. There is a bolt on the side of the value cover under it, does that free it? It is on a late 2a, and has...

Lucas has struck again ...... I seem to have a short between the running light circuit and the reverse lights...... If I shift into reverse with no lights on, getting back up (white) and tail lights on...... or if dash toggle set to running lights, then back up lights also come on along with...

Been having trouble with the series 2a brake light switch (servo mount) - switch removed from the truck and on a meter makes contact only about 60% of the time - its a new lucas part too...... Took one apart, fresh contacts, just crappy contact..... have read the posts to insert a relay to...

Greetings - New member - based in Nor Cal with a '69 Bugeye Series 2a. Dad worked for Rover / BL / Ford in parts (Brisbane CA) for his career. Looking forward to projects on the truck! JGoldie