Search results

Hi all got a Range Rover L405 The original rack failed when it was parked up started it up and instantly now steering it had been parked for 2 weeks, so we got a replacement complete with motor-rack-rack ends-track rod ends. So we fitted not a bad job, but we still don’t have power assisted...

Hi all, my dads just finished putting a new engine in his L322 (TD6) and just finishing off little bits and bobs, has anyone or anyone no of any diagrams of the vacuum lines, if anyone can help thanks

Yeah got whole new arm, back bush and drive shaft fitted it and the back bolt that hose throw the bush on the arm snapped

To be fair it wasn’t until I nicked the ball joint out the arm fell apart, is not my car it’s a friends. The shaft was fitted the first time buy just removing the front arm bolt and swing the arm down an shaft cam out, well it’s all going back together tomorrow

Haha found the issues lads

Yeah it came off a TD4, but am thinking something has moved. Why would it of poped out in the first place, as yous say the bottom arm is canny rusty, will keep you updated

That’s the old shaft

Hi all my friends td4 freelander has been having a with its front n/s drive shaft. last we we were taking a left hand corner at 50/60 and it popped a shaft but it left the cup in the box and spilt the inner cv boot it did carry on driving but shaft was wrecked. Now the second had shaft is in, it...

Hi all I have a R reg p38 2.5 auto It has been fine and all of a sudden she will over heat if standing ticking over, but drive flat out and she’s fine, Checked VC working Had new rad 8 months ago New waster pump 8months ago Starts off the key every time not using water Could it be a sticky...

Sorted fitted as it yous said had to bleed slightly but done in 1hour all good Thanks lads/lasses

H hi thanks how do you mean with the slave clamped down do you mean don’t fit it into the bell housing and clamp it so it carnt extend the out ?

Hi all been finishing the ids and sods off on the disco the clutch as always been abit soft and low since we got it so went and did a full bleed, pump the pedal hold it down crack the bleed nipple, fluid little bit of or did this 7-8 times and no pedal back bleeding with a easy bleed no pedal...

Hi all just wanting some info I have fitted a CDL to my 53 td5 manual disco You no what am going to say the only to available spade connectors to for the diff lock switch, only light the gear box temp light. I no that it can be retro fitted to light the diff lock light dose any one have step by...

This is the bit I am on about just incase

So I can just unbolt the the old (non diff) front out put from the transfer box and put the other one on? how can I check the pre load ?

Hi people was just wanting to no on the transfer box for the discovery 2 I no mine dosnt have the diff lock pin at all on the front out put housing but I have a full spare transfer box with diff lock my question is do I have to change the full transfer or can I just take my old front out put...

The smell is in the exhaust gases it smells like a old Perkins diesel to, there is no blue smoke if anything it’s white grey colour

Hi I have a 2002 td5 d2, I was parked up waiting for the other half to finish work, it was cold as it had been snowing so I had the disco running been sitting idling for 20/30 min I look in my mirrors and just gave her a gentle Rev to see what colour if any smoke as she’s due a service, I seen...

Ok glow plug light is on on the dash when starting I will pull them out and test them where is the relay located in the engine bay or in the car fuse box