Hi people was just wanting to no on the transfer box for the discovery 2 I no mine dosnt have the diff lock pin at all on the front out put housing but I have a full spare transfer box with diff lock my question is do I have to change the full transfer or can I just take my old front out put section off and fit the new one from my spare ?
Disco 2 diff lock
- Thread starter Markw48
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
as long as you check the diff preload after
Bennehboy
Well-Known Member
- Posts
- 2,215
- Location
- Huddersfield
The main differential in the LT230 has preload set by a selectable shim that sits on top of the bearing that the front output housing holds in place, so swapping that housing over can either give you too little, the right amount, or too much - basically you can't guarantee that the housing is the exact same dimensions.
If you want to waste an hour or so of your time you can see a full rebuild & teardown of both the LT230 & an R380 in this thread -> https://www.landyzone.co.uk/land-rover/lt230-rebuild.247618/ the R380 comes first and the bit you're interested in is on page 23
James pretty much showed me how to do this and he might have a quick way to check the preload, but my guess is it won't be easy with the rear prop attached and the gearbox input shaft inserted into the LT230.
If you want to waste an hour or so of your time you can see a full rebuild & teardown of both the LT230 & an R380 in this thread -> https://www.landyzone.co.uk/land-rover/lt230-rebuild.247618/ the R380 comes first and the bit you're interested in is on page 23
James pretty much showed me how to do this and he might have a quick way to check the preload, but my guess is it won't be easy with the rear prop attached and the gearbox input shaft inserted into the LT230.
Similar threads
