Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. M

    Autobox temp following Kenlowe fan install

    Hi, I've installed a Kenlowe 17" fan on my disco 2 v8 auto. since then when in slow traffic or uphill work my oil temp light illuminates, sometimes it stays on, other times it goes off however I'm concerned either way. I understand the principal that the viscous fan constantly cooled and now...
  2. M

    A little project

    Right my v8 Disco has started to show signs of the cylinder head crack so I am gonna replace the engine. I've set aside the summer to do it so time is not an issue. I dont want to buy a new car as I love a challenge. I'm lookign at replacing with a 4.6 lump and I knwo the NAS spec discos have...
  3. M

    Good vibrations

    Sports fans, whilst driving at about 50 I am getting a vibration through the wheel. any ideas? I've had the tracking looked at and the tyres are all at the same pressure. regards
  4. M

    Help its windy today!!!

    Has anybody got, or know where I can source a replacement Drivers door for my Discovery 2? I opened it at work today and the wind took it off me and now I have a dents in it by hinge and the check strap mounting as cracked the door metal around where it sits. the car is bhlenium Silver regards
  5. M

    Performance Manifolds

    Does anyone know if you can buy uprated manifolds for the Disco 2 V8? Mine has a crack in it on one side and looking at rimmer bros, the disco 1 full system is cheaper than landrover want for the part. This got me thinking about uprating, however I cannot find any for the series 2 disco i...
  6. M

    Fresh Filter, Fluid and 90 minutes :-)

    Well this mornign in the rain I set about draining the auto fluid from my disco 2 v8, following the removal of about 6 pints of fluid, i set about removing the filter and promptly replaced it with a new one, remembering to clean the small magnet of crap. I got the filter and gaskets from...
  7. M

    20's on my Disco 2 V8

    Guys, I'm looking at getting some rangerover 20's for my Disco 2. I'm gonna keep the standard ES 16's as I want to put some decent grabber off road tyres on them. For the many miles that I do on road, would 275 / 45 R 20 be the right size choice? current tyres are 255/65/R16
  8. M

    disco autobox not going into park

    I pulled up on the mother in laws drive on christmas day and found that the disco 2 auto box will not allow me to select Park. Its been like this since. I have taken off the top selector cover in the cabin to ensure that its not jammed by a coin or something else. does any one have any ideas...
  9. M

    Autobox Change

    Hi, I've got a disco 2 V8 with an auto box. Its the 4HP22EH box, now I am looking at upgrading to the 4.6 lump as I have mentioned before. I would at the same time look at refurbing my gearbox as its covered 100k. I read somewhere that the 4.6 discos use a 4HP24EH gear box. should I look at...
  10. M

    Auto gearbox concerns

    Sportsfans, My Disco 2, V8 drives like a dream and pulls ok for a large car. My concern si around the feel of the accelrator when pulling away when the car has driven for a while. On cold start the feeling is not there but after its warmed up its almost as if you can feel a vibration in the...
  11. M

    ABS pump

    Gents, when I switched my disco off last night I poped the bonnet to check water level in screen wash etc and heard a faint pulsating noise. I finally tracked it down to the ABS pump. is this usual?
  12. M

    Dis pack gone?

    I think my dis pack has gone as before I changes the leads and plugs I saw some arcing against the firewall. Since changing the leads and plugs I got a small puff of smoke from the diss pack area and now the car is ok on tickover, but under load has absoultly no power. am I correct in my...
  13. M

    disco gearbox issues, auto

    the Disco (Discovery 2 V8) has been sat for three weeks while I changed the heater matrix. I've put it all back together and it starts first time. my question is this. It revs ok, but I tried to drive it and it wont go about 1500 revs and it crawls only. at first i thought I was in low range...
  14. M

    Two spare plugs

    I've just replaced my heater matrix on my disco 2 v8, on putting the car back together I have two wiring plugs that I am unsure about. first one is in the steering coloum, white plug with a few wires coming out of it, no where on the stalks behind the steering wheel can I find a plug for it to...
  15. M

    Facia Adaptor for aftermarket radio

    Hi, is there a facia adaptor to go in the Disco 2 for fitting an aftermarket radio? I have removed my Orignal Equipment Alpine system to find that behind it was two screws through the dash board. these are now on show with the new rasio in. does anyone know if you can get an adaptor or cover...
  16. M

    v8 rocker cover bolts

    hi, anyone know what kinda tool i need to buy to take the rocker covers off of my Disco 2 v8? I need ot change the gaskets and the bolt tops look like little round cogs? regards
  17. M

    Nightmare

    Guys, I started to chage my heater matrix yesterday, got the dash out etc but lost light so continued this morning. I must say what a chor it is, had to take the top off the engine in order to get at the air con pipes on the bulk head. anyway its out now and i need to get a couple of parts...
  18. M

    Best sounding exhaust for a v8 disco 2?

    whats the best sounding exhaust for a disc 2 v8? mine needs changing soon as middle box on its way out and i would like to replace with a stainless one. if you have photos of your, please post them too# regards
  19. M

    Noisey steering on my disco 2 v8

    my steering is noisey and virbration and groaning felt via the stering wheel. what could it be?
  20. M

    Harmon Kardon System swap

    Sports fans, I am looking at swapping out my current radio with multi CD in favour of a kenwood item. will the Harmon Kardon speaker system hook up to this or would I need to replace the speakers and amp too? does anyone knoe if a wiring adaptor is made for this conversion? regards
Back
Top