Search results

Matgriff thanks for the offer, but I am in Glossop, quite some distance away, but again thanks. Having it plugged in again tomorrow. Pete

had the 3 amigos plus the handbrake light on, had it diagnosed and the fault was the shuttle valve. Replaced this, and lights went off. 3 days later all 4 lights returned, and will not go off. Any ideas would be welcomed/Pete.

I also had the same 4 amigos on 3 weeks ago, the diagnosis was a faulty shuttle valve, change this, now all light have gone, a cheap quick repair/Pete.

For the second time this year, I have had a guy repair a leaking ace block seals, and today noticed that it is leaking again. Don't want to have a conversion done, just the leak repaired once and for all. Anyone in the Glossop area that has any experience of repairing these would be appriciated.

Fitted mine a few weeks ago, had to cut some of the registration plate away. You also need a special rivnet gun in order to fit, not a rivet gun. Borrow one from your local garage. Pete.

Thanks guys.

Thanks Guys, it the side with 2 pipes connecting into it. None of the pipe are coroded, it is just leaking from where is sits, after tightening the nut, it has nearly stopped it, but I am a bit weary of stripping the thread.

Didn't Know that. It's the one under half way down under on the driver side, bolted to the chassis. It has several brake pipe going into it. Thanks for your assistance.

Hi Guys. Got a small leak from the solenoid valve, tightened the nut up as far as possible, but still leaking, need to replace the O ring I would think, the question is, will I have to bleed the system after removal Thanks in advance/Pete.

After a 25 mile drive the gear stick is feeling tight, I have replaced the gearbox oil with MTF90 however the problem is still there. After a few minutes everything is back to normal. After reading some post on here, my thoughts are now with the plastic selector ball at the bottom of the gear...

From memory I am sure it's the large size/Pete

I have a rear diff (24spline) for a Landrover Discovery td5. Was going to change mine on my earlier vehicle but sold it before getting round to changing it. Anyway your welcome to have it free of charge, providing you pay for collection from SK14 area. Just let me know if your interested in it...

Think you may need 2 credit cards, side by side. Pete

Managed to replace the window regulator and motor. Bit fidgety but straight forward, didn't remove the window used rubber wedges to hold it in place. There were two faults with the removed parts, faulty motor, and there was a bend in the upright, so job done. Thanks to those that wrote with...

Thanks bobupndown. Never changed a regulator, do I need to remove the wing mirror in order to remove the glass window, also any tips would be appriciated/Pete

Thanks Guys, just ordered one together with the motor, just in case it's that. Checked this morning and I am getting power to the motor, cannot see anything wrong with the regulator, but I cannot see proper until I remove it. Thanks for your input. Pete

landrover discovery td5 2003. The front drivers window has stopped working. Checked the switch and all is well here. Removed the panel and checked the wiring, cannot see any faults here either. Next going to remove the motor and the regulator and see if the fault lies here. Any ideas or...

D2 Td5. Rear inner arches measure 58" slightly under 5 foot. Hope this helps/Pete.

Thanks for the replys gents/Pete

Driving the D2 and plugged the phone charger in, then for some strange reason the 3 amigos appeared, stopped and unplugged the phone charger, turned engine off and restarted, and everything fine. Very strange. Any ideas