Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. L

    Hissing from Engine

    Hi chaps, I have one of those noisy fuel pumps that buses for 30 seconds then stops. I have learned to live with it. Today whilst I was fitting new headlight bulbs I had the ignition on but had not started the freelander. From under the engine covers I could hear a hissing sound that...
  2. L

    Wheel arch inside panels

    Hi chaps, just bought 2 of the panels that sit in the top of the wheel arch. My freelander has never had them since I bought it and crap splashes up into the engine. My question is, what do I use to fix them in place? Thanks guys
  3. L

    Reverse Lights (not the switch)

    My reverse lights have not been working for a couple of months also the rear wiper has stopped coming on when I put it in Reverse. Had a new switch fitted today but that hasn't solved the problem. The mechanic checked the fuses and bulbs and as far as he was concerned they seemed fine...
  4. L

    Odb2 & 2002 Freelander

    good evening chaps, I have been looking at a Hud display on EBay that plugs into Odb2 port. My question is this, will it work in my 2002 freelander Odb port? Thanks
  5. L

    TD4 Water Pump & Turbo

    Hi chaps, a few days ago I had to have a new water pump. Since then my turbo makes a spluttering sounds when I get to about 50mph and acceleration is poor. My question is, have the garage caused this when changing the pump? Any ideas what it can be? Thanks
  6. L

    Soft Top Clamps

    Hi chaps. I have just bought a soft top for £31 it is in quite good condition except it is missing the L & R hand Clamps that fit either side of the door. I don't suppose anyone on here has any left over that they would be willing to sell? They are about £36 each on the T'internet which...
  7. L

    Cleaned Inlet Manifold and now..............

    I have just cleaned out my inlet manifold, refitted and taken for a test drive. Now my freelander has no acceleration when you put your foot down and is spewing black/grey smoke from the back. What have done wrong? Or is this a side affect of cleaning and will improve? Thanks
  8. L

    Propshaft

    Hi chaps. So I have taken my propshaft off changed the bearings but now I can't get the UJ's on either side to fit back on the VCU splines. Does anyone have any advice please? Thanks
  9. L

    Squeaking from IRD/Pinion

    Hi chaps, When I bought my 2002 td4 in sept 2013 right from the start it had a slight squeak that turns into an egg timer type of ticking sound as I go faster. This noise seemed to be coming the engine area directly below the centre console. I haven't really given it much thought until...
  10. L

    Gearbox problem

    Hi all, For a few weeks now I have had a noisy transmission. I had put it down to a VCU support bearing needing changing. I sent it to the garage today to be looked at and I have been told that it is a gearbox problem not VCU bearings. The problem is being caused by the extra strain...
  11. L

    Engine Cover Bolt

    Hello everyone, I have a 2002 TD4. I have gone and lost one of the bolts that hold the Engine Cover on, speficically the cover that goes over the injectors and not the one that covers that air filter/oil cap. What size bolt do I need to order please? As I am getting a small amount of oil...
  12. L

    Blank Button

    Hi again. I have bought a small Thermometer and was looking for somewhere on the Dash to fit it. I have a 2002 TD4 GS. On my dash above my fog light switch there is a blank switch and I am thinking of fitting the thermometer into there. When I have prized the switch off instead of...
  13. L

    Oil Extractor Pump

    Hi there, I have only just recently bought my first Freelander TD4 and am looking to perform an oil change on it. I don't have anywhere under cover to do this and I can't wait till next year when the weather gets better. My question is: Has anyone ever used an Oil Extraction Pump to change...
Back
Top