Freelander 1 Where through???

2004 TD4 HSE 120k
I want to connect some spot lights but I need a switch inside.
Anyone knows where can I pass the wires inside any place for the effect of rubber Gromit?
Many thanks

the wiring runs through the bulkhead on the left side of the vehicle, from the fuse/ecu boxes, there is a bit of room in the original gromits for new wires, but you'd then have to feed the wires through to the drivers side behind the dashboard and that could be a pain. Oftentimes these vehicles have preexisting wiring for options they weren't built with, such as heated seats etc, have a look behind the dashboard on the right hand side for original wiring there for the fog/spotlight switches, if that's there it shouldn't be too difficult to get an oe switch, and find the other end of the wiring to drive your new lights.

Front fog wiring is there, but will be used for fogs on an HSE.
Spotlight wiring wasn't fitted from the factory, being a dealer/owner option.
I have a complete LR spot light kit, so can take pictures of the wiring if needed, before I put it on ebay.

Hello.
I have the wiring . I was looking to know about a place were it go inside the car. I have seen a spot close to were the sensor of the bonnet is there is a entrance there.
SO far is the best i have seen

I have those lights on mine, the wiring (as mentioned in a previous post) goes through the grommet with the larger loom on the passenger side. I have attached a couple of pics for you to see - they aren't the best as there's not a lot of space there.

Many thanks that will perfectly..I will keep you guys posted
I have send you a preview....tell me what you guys think