Wing removal

bignumpty · Mar 3, 2019

GreenHornet said:
Both wings are the same.

Remove the inner plastic cover, screws etc are plain to see. Then there are four or five 10mm bolts which you can see if you open the door and look towards the wing. Once these are undone you can then unscrew the large Phillips head screws along the top edge and a small 8mm bolt by the bonnet hinge.

Obviously you will need to remove the indicators and the repeaters.

The wings are normally held on with sealant so they need a good tug. All in all about 5mins is all it takes.

Thanks for this reply , I was going to ask the same question but you have provided me with the answer. Thanks again.

Shedload · May 19, 2020

GreenHornet said:
Tiger seal is the best by far, however you can get a descent sealant from fleabay call Fulva I think. Don't mix it with Vulva as that's a different type of sticky situation.

Bang on. You don't want that a sealing !

Shedload · May 21, 2020

Ok, I have removed 10mm bolts from A-pillar and along top of wing.
Also one 10mm from behind front indicator and another on a small bracket behind mud flap.
Am I ready to 'tug' ?
Disco' 2 by the way.
Thanks

Wing removal

bignumpty

New Member

Shedload

Active Member

Shedload

Active Member

Similar threads