Recent content by wooody

Ahh, thanks for that james.

Good evening folks, I fishing for information about disco 2 rear wheel bearings, is it possible to change just the bearing by pressing it out of the hub and sourcing a new bearing, or can this not be done? If so it's take the plunge at £150 bearing! If you have or know if it can be done please...

thanks chaps. appreciate it :)

Hi chaps, I've got a 2000 discovery td5 and my front diff has failed, the pinion and crown wheel have excessive wear, and I'm wanting to know if a diff from a discovery 1 300tdi 24 spline would fit? If anybody has changed one of these before? :)

Wow, best thing for that booted and suited driver, is to stick to the tarmac!!

thanks steve, its all ok the ace has been removed, had coil conversion. sunroof was leaking but sorted it now.

Wiltshire.. no need for the shirtyness!! via general chat.. rather than going to the disco section and trawling through.. sorry if it was too much hassle to ask!! cheers james, yeah i feel confident enough, its a decent truck, no real faults just a slightly leaking sunroof.

.. Afternoon chaps, were off to look at a 2001 disco td5 for a family member to purchase.. Although we have 4 300tdi discos in the family a td5 is something different. So if you have any pointers of common faults what to look for etc, it would be very appreciated thanks.

.. Hey mate, mine had the same problem, it was due to the play in the swivel ball (king pin) bearings, easy to sort if the bearings are in good condition, just take a shim out of the top king pin. Give it a road test, if that sorts it, I'd say best to strip it and regrease the bearings too keep...

I would just get them out the box, fit them, then off you go. They will be back off in 6months, I fitted some on my disco, after a couPle of pay and plays a few rocky tracks they were shot.. I've got britpart cellular dynamics at the min and there cool. :D butt the pro comps do ride well on the...

Hi, assuming that the bolts holding the pulley to the pump are tight, then you will be best of replacing the pump. They are relatively cheap and easy to fit. Search for paddock motor spares they have a vast range of land rover parts. They also post worldwide, I'm sure you will find a thread on...

... Tell them to let the pressure out first :D

Yeahh we've done the job now, we were going to got for the engine out route but opt'd not too, I wasnt difficult just heavy work, we also changed the fork for a heavy duty one and replaced the slave cylinder :)

Well your crazy! Lol, we rang a specialist near us and they quoted £450 + parts. There easy enough just heavy work :)

niceee :D happy digging!