Recent content by tempest
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
T
I understand comments but i have just got a field in the middle of nowhere. Its not a case in need a winch but its a just incase i need to get out of a difficult position and would not like to leave my 90 by itself ( it wouldnt be there intact for long) . I would like something that would get...
-
T
Employed a young lad that was more intrested in his phone than getting on with the job. Didnt last long. Does this count
-
T
I am looking at putting a winch on my 1994 defender 90. I dont need one to pull me up a cliff face but enough power when needed. The winches i have looked at are all in lbs not kilos. What size winch would people recomend.
-
T
What sealant are people using to seal the sump on a defender 300tdi
-
T
Just put a rev counter on my defender 300 tdi. Could someone tell me what revs they tick over at so I can set it up propely
-
T
I used fiberglass to make it sturdy then bought some 4 way streach material off eBay .use heat resistant spray glue .I took my time and was impressed with the finished product
-
T
Going to put some chequer plate wing tops on . Is there anything I should put between the chequer plate and wing or should I rivit them straight on
-
T
Going to replace Cam belt on my defender 300tdi. Bought a kit and came with an instruction that when fitting the idler pulley stud if there is not a 2mm by 45 degree chamfer to where the stud goes in to make one with a countersink tool. Can anyone tell me why . Is there a specific tool to do this.
-
T
Going to put a new timing belt on my defender 300tdi. Where's the best place to buy a kit. (Cam belt /tensioner etc ) what should I look out for and what should I avoid
-
-
T
No. It's at the other end near the air box .It's only about 5mms wide. And comes out of the pipe with an elbow
-
-
T
I'm not shure .when I got the hose it had that small pipe on and couldn't find where it went
-
-
T
Putting my 300tdi defender air intake back to standard. The pipe that I have got. from the air box to the turbo on the first bend from the air box it has a small pipe connected to it. Can anyone tell me where this goes or is it needed because I can't see this pipe on any diagrams.