Recent content by rickdulas

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. R

    My little 90

    Bulkhead, cappings, inner wings, loads of brackets back from galvanizers... we have progress... wiring loom being repaired.. new fuel tank arrived...wheels and tyres off Ebay.. rebuild is go!!!!!
  2. R

    wiring loom

    Thanks guys... got the boomsang looms and a load of connectors this week.. I'll order the wire tomorrow and off we go.. thanks again
  3. R

    Defender 110 at the office

    £600 for that genesis grill?? I was just messing about with some scrap steel, a hole saw, some mesh and bits of paint and I knocked this up.. got to be at least £800
  4. R

    wiring loom

    Hi guys.. just starting to put my 90 back together, ( pics in members vehicle forum), and I've come across a bit of a snag... headlight wiring loom is burnt out in a couple of places, nearside I think, probably about 2 meters from the plug (see pic 1) On close examination I've also found...
  5. R

    1984 One Ten

    Nice.. Very nice
  6. R

    My little 90

    In what way familiar?? if you don't mind me asking??
  7. R

    My little 90

    Thanks.. got loads more to spray on it as we go on...Anything that cant be seen will be covered in Vactan and Raptor.. Anything that can be seen should be galvanized and covered in zinc primer before painting..should outlast me anyway ..f***ing rebuild will probably outlast me
  8. R

    My little 90

    Wow, a reply from a place more remote than the Falklands : ) : )
  9. R

    My little 90

    Started a rebuild on my little 90, so I thought I'd share some pictures.. here it is when I bought it in 2010, while working in the Falkland Islands.. then arriving home.. used for a few years part of the collection strip down starts yuk.. but not bad for 30 years.. had a rear xmember when...
  10. R

    Bulkhead project (inside vent panel)

    That's where they all die though.. surprised no one makes a part
  11. R

    Bulkhead project (inside vent panel)

    Mine wasn't quite that bad, but new vent panels, new legs?, new feet, new footwells and lots of cutting plates and welding resulted in this.. just back from blasters, going to galvanizers
  12. R

    Sankey for sale

    FFS you couldn't be much further... shame.. good luck with your sale anyway
  13. R

    Shot blasting

    that was just a bag of kiln dried sand.. no dust and gives quite a good finish on the wing... water and sand everywhere though
  14. R

    Sankey for sale

    Whereabout are you mate, and is this still for sale??
  15. R

    Shot blasting

    No, the 3rd is the 1st again It really does wok well. Better than my computer skills
Back
Top