Recent content by peterjjoc

Thank for the responses, points noted, now to get it all back togeather

Hi, I cannot change gear with the engine running, i can change gear with the engine stopped, i can start in gear no problem. Master cylinder fine, i have removed the spring from the clutch inn the cab and there is still considerable pressure on the pedal, the pressure plate and release bearing...

Tried slave and master cylinder all working fine, removed inspection hatch cover on bell housing,pressure plate seems to be working fine when i press on the clutch it goes in and out, looks like gearbox will be coming out over the weekend, Thanks

Thanks guys looks like a bit of investigating for the weekend, I have seals for the master cylinder so I will start with that, thanks again

No drop in fluid levels looking like the clutch so

Hi, I cannot change gear with the engine running, i can change gear with the engine stopped, i can start in gear no problem. I think it could be the master cylinder?, i have removed the spring from the clutch inn the cab and there is still considerable pressure on the pedal, which would say...

Thanks UVS166 started i gear and it worked, tried reverse a few times to start, and then started in first a few bangs from the clutch alright, all seems fine now, will drive it more often now to ensure it doesnt happen again, Thanks for the prompt and effective response,

HI I havnet driven my land rover series since about April, now i try to get a gear and cant when the engine is running, is i switch off i can get all the gears. If i start the engine i cannot get any, the gearstick will go to the reverse selection, when i press in the clutch all seems the same...

Hi, I managed to replace the syncho clips without removing the gearbox, i road tested and all worked fine for about 2 miles, removed top of gearbox, and one of the synchor clips was partially out, the clips seem to be able to move back and forward in the synchro is this ok or should they be...

HI, Just managed to replace the synchro spings in my gearbox, the 3rd and 4th sysnchro was moving back and forward all ok. I have installed the selectors and put the cover back on. Now, i have reverse, 1st and 2nd but no 3rd or 4th, would the selector be in wrong way, There are no noises or...

Sorted, the hinges moved enough to align the door, Thanks Peterjjoc

All original that i can tell, i bought the bulkhead with pillars intact

Hi, I have replaced the buklhead in my series 3, the problem i now have is that the doors wont fit correctly, drivers door not to bad could eb adjusted, but the passengers door seems way off. It looks to be to low. 1 door ope is 35" and the other is 35.5". I wouldnt mind i took great care in...

Hi, Juest replaced bulkhead and my brake lights stay on all the time, i have checked the wiring to the brake pedal and its ok, Any ideas

Hi, Just wondering how you line up the seals for the bulkhead and windscreen, and also the roof to windscreen seal. Would clear mastic be ok the seal the bulkhead to wind screen. Thanks