Recent content by Mineleakstoo
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
The headlining material is from Woolies Trim and the adhesive is trim fix search on eBay it's red tin with grey front and some good deals on multiple tins its good for 120 degrees. One thing I would say is if cut the fabric around the edges leave a good inch all way round I did a few slits quite...
-
-
Hello group just thought I'd share a couple pics of the front headliner in my defender 90 re-covered, bought some headlining at £8.50 a metre from woolies trim (4 metres enough to cover mistakes which there were) and 3 spray tins of trim fix which after using impact adhesive as a test was a...
-
I take it you'll not be testing it anywhere deep then? But if you are my Mrs has always wanted to go to the area of the Mariana trench.
-
You seen Texas chain saw massacre? We all know how that ended when someone stopped to 'help!'
-
After driving down to Morroco in August and back via Millau altogether just over 4000 miles 4up in a defender 90 I parked her up and only this week got back in the saddle so to speak. A new battery was all that was required (and a day with all the windows down and some wet wipes for a mould...
-
Washed it, inside and out.......
-
Roads are good, even driving in Marrakech was no problem.
-
Where are you going where you will be using it? I have a 12v ring automotive shower it's fantastic.
-
You know general stuff, assurance frontiere where it is in tanger port, fuel 83 cents a litre and frequency anything of help to make smoother. No dodgy bellies got those in France, eyes of needles and all that :lalala:
-
Just got back from morocco, 4 of us in a 90, only mechanical problem a corroded seal in clutch cylinder back street mechanic fixed it went off for an hour to get the part. No gangs no problems with thefts, and Moroccans are genuinely friendly people. Will get a report and some pics on here when...
-
Wheel off and are you going in over the top of the wheel assembly to get to the top caliper bolt? So looking down on it; I've just done both rears and the spring wasn't an issue in any way.
-
-
Did you get the torques? I finished mine today and have them here. Yes I found the second set far far quicker and in a bizarre way I bloody enjoyed doing it.
-
Epoxy metal and radiator hose tape. Takes up no space but handy