Recent content by mike polly1
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
never had any problems with mine till becm went down cos i put wrong eka code in then needed another driver door door latch as that went just a few little problems but thats all the fun of owning a p38
-
think seen them on ebay new batt and fob cover but dont buy a full key as thay wont work on your car
-
if all doors open apart from passanger side with fob .and open with key then its pos the actuators not sending a signal to the becm
-
yep claw is right .there is no switch under seat
-
thanks to irishrover for sorting me the rave cd
-
sorted out the cruz control problem out found it to be the pipe not connected under bonnet gemsdad and irishrover put me right thanks lads
-
got a decent roof linning today thanks to gemsdad for sorting that one for me
-
-
heat it up with hair dryer peel it off and if any glue left on window u can use a little petrol on a cloth wipe it and the old glue will come off thats how i did mine .BUT REMEMBER NO SMOKING
-
bet the drivers on other side of the road thought is this guy real bet not many useable parts left if he hit one
-
i fitted a range rover l322 roof spoyler on my p38 went on ok but had to drill holes in the top part of my tail gate fit with self tappers screws and fill the holes and paint but you also have to re root your wires underneth the spoyler for you high level brake light .and if your struts are not...
-
-
as others say not to bad to do i took mine off in about 45 mins bit fiddly .but do use axel stand and a good jack in case u go underneth to remove the pin at bottom of bag.u should have fun just take your time
-
mine aswell sat at 12 and towing went just past but that was up hill
-
i changed the steering wheel on mine every thing worked fine till i changed it but a couple of the lads sed it could be the casset at the back of the wheel at fault