Recent content by middx90owner

Hi all Can any one tell me were the Drop arm ball joint & Drag Link Ball joint are located I have had a pre MOT inspection done and aparently these ball joints are warn and I cant find them in the Haynes manual. Also how hard/expensive is it to change from a truck cab to van type body One...

Hi yes pedal return spring is attached I used paddock spares drilled and grooved discs and EBC performance green pads

Hi did the same last month on my landy 300tdi just removed the old one filled the new one with diesel and re fitted it and it runs fine

Hi All My clutch pedal sometimes stays down after a gear change and I have to flick it back up with my foot any ideas breaks grind at low speed just before you stop like when the pads are worn and need replacing but I have changed discs and pads all round any ideas...

Hi All Is it safe to run commercially produced B100 biodiesel in my 300tdi as it says on most of the suppliers sites that it is safe for vehicles less than 13 years old mine is 14 years old. Cheers

Didn’t realise that checker plate was swear word just wanted to cover the hole left when I remove spare wheel holder without buying a new bonnet, just so as I know what is deemed acceptable may be you guys could publish a list or something so us new boys don’t go making a land rover fashion faux pas

Hi all how do you remove the spare wheel holder from the bonnet of a land rover as I don’t use it and want to checker plate the bonnet Cheers

Hi again guys time to pick your brains once more any one know were i can buy a security mesh window cover like you get for normal defender windows but for the slidy rear window on a pickup, i managed to open mine just by applying a little force and any one else could do the same . Cheers oh...

Hi Guys 1) Have a grindy squeak on or near full lock worse when reversing 2) A clunk when taking up drive pulling away changing gear etc any ideas for both. cheers

1994 90 truck cab 300tdi one owner from new service history 82k 6 months tax/mot paid £3'600 As its my first land rover just wondered if it sounds like a good price Cheers and thanks for advice on other thread about the heater fixed it and is working great.

Hi all Just wanted to say thanks for the advice about my heater the cable had slipped on the heater box so it didn’t go all the way to hottest setting, all fixed now and its nice and toasty in my truck cab Cheers Dudes

Can I pressure was my engine and engine bay, any areas to avoid should I leave engine running? Are Axle breather pipes standard I have one on each axle running along the axle and up under body cable tied on, if yes do I need to extend them for deep wading? Cheers

Thanks for the ideas its seems I was wrong to assume that landy heaters are crap will try the suggestions and look forward to not shivering next time I go out.

Are the heaters normaly crap in defenders mine is no use at all, can you upgrade them I think some army ones have arctic heaters fitted can you get them fitted or buy them. Cheers

Hi Guys Were do i find the paint code for my 1994 300tdi 90, if any one can tell from the pics would be a help cheers. Also are the heaters normaly crap in defenders mine is no use at all, can you upgrade them I think some army ones have arctic heaters fitted can you get them fitted or buy...