Recent content by MAB1

can you open door from inside silly question i know, mine did same thing ended up replace the full latch assy.

Do a voltage check on your battery before starting, The autobox requires good stable voltage and will flash up the error you are getting, if voltage 12.7 and above you can assume battery ok and then look at cable to and from xyz switch. good luck

can you email me and explain what u did thanks

low battery voltage can cause this, let the engine run for a while ensure voltage reaches a minimum of 12.75 volts to power up all the electrical circuits correctly. hope it helps best mark

My son disco 1 has 249k and still runs sweet, oil change every 5k inc filter .had the car since 92k on the clock, engine service like previous mentioned, best mark

does it run ok once you restart engine, i had same problem one of the injectors was failing after running a mile or two, turn engine off off left it for 5 mins then it ran ok for 2 mile's . get it on diagnostics showed faulty injector if thats the probelm. best mark

I had s & m lights come on, battery voltage low , start you engine and let it run for 30 seconds or so , this will charge battery enough so fullvoltage is at the gearbox, it they still come on after that then check alternator , if that ok then i would look at xyz switch. hope it helps. best mark

I had the same problem when i went off roading and waded through some deep water , more like a liquid cement then water. any way other a period of time my steering progressivly got stiffer and heavier, steering would not return to centre without me pulling it straight. the steering column from...

could be low voltage from battery, had he same problem , fault would reset once i swicthed off ignition.try starting and let the engine run for 30m seconds or so, let battery recover, if fault does no show , have battery and alternator checked out. all the best .mark

thanks busterbus appreciated it ,better go and order me bits ,looks like i will be getting stuck into it at the weekend. cheers again guys

cheers v8 will do a search, thanks again

hi everyone can someone advise me on how to change the front drive shaft nearside cv gaiter it appears to be leaking oil/grease.my steering has gone stiff and i am assuming this is the problems as all other ball joints appear ok, any help or advice appreciated.

thanks guys for all your help manage to sort it out and fit new tensioner, appears quite again.Urban Panzer the crank pulley you have mentioned what symtoms do you get when the rubber starts to perish ? just thought i would ask to be on the safe side.

hi everyone me again car as develop a squeek replace serpentine belt appeared to have cured for a few days now squeek back again i asume it the belt as slightly stretched .if i loosen the belt and then allow it to take up the slack squeek stops , so i want to change the tensioner itself , but...

Hi Guy's thats for your advice , finally got to work on the car today, took off door card , then activted window up / down ,there was three bolts which had work loose.lowered window to down position then just tightened the bolts , done jobs gud un. Cheers again