Recent content by Loonytunes
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Hi nodge68 drains all clear. Amount of water getting through is like it’s open but fully closed. That’s what makes me think glass seal
-
Shame was hoping could use glass seal off disco 3 if a bit longer I could shorten it it should still join at the cut
-
Hi all does anyone know if the disco 3 use the same sunroof mechanism and glass. As a Freeland 1 2005. Trying to find a seal for the glass on mine. And vaguely remember reading some where that they both suffer same proplems. Which has made me think that both models use the same unit
-
And just a heads up near side gear box seal now no longer available from Land Rover. They only quote for britpart
-
Can not be any worse than the rear diff kit I got from Land Rover. Oh sorry same manufacture for spares
-
IRD rebuild with britpart kit
-
Hi all was hoping someone on here has rebuilt there’s with the britpart kit. I’m am in the process of doing mine and after waiting for casting to come back from cleaning cannot for the life of me. I can not remember or find the diagram I made up. So my question is do any of you smart people have...
-
Yep done that. Looks like the switch in tailgate lock not working properly
-
Thanks for info have managed to open it by gently lifting trim.have fitted new regulator. Just need to figure out how to tension cables as window does not drop down fully I have to pull it down about an inch then it stops.
-
hi all l need some advice on how to remove trim above tailgate window. As my window regulator has gone and can not open boot to enable repair. And it looks like the trim is removable but is that from inside or outside. Cheers for any help
-
Sorry that’s 47098 casting for the early diffs
-
Oh before I forget check diff casting numbers as the made a change mine was a 47089 casting which is the early one the later ones I think start with 51 on the casting. The later one take a larger bearing. Done to try and make them harder wearing. But from I’ve read it just made the castings...
-
Hi done mine about 2 months ago. Not that hard to do. Worst part is doing up front pinion bolt. As it needs about 375nm torque. Other than that straight forward. Just make sure all casing is clean and all gearing is in good condition no wear on pinion and crown. No need for dial gauge as there’s...
-
Hi all needle bearings on order will update on outcome when done. Fingers crossed it sorts it all out.
-
Thought of that but did not want to be throwing 3/4 hundred quid at a 55 plate car. Plus enjoy doing my own repairs. No matter how much swearing blood and sweating it takes and these take it all.