Recent content by crofter65

Thanks jamesmartin.

Hi, I am going to fit a 300 TDI Discovery front axle to my Land Rover 90 (1984) and I am wondering if the later arms from a TD5 would fit the 90 Tia.

Thanks Tottot, I am aware of the radius arm size difference, the reason I want to use my original callipers is that I did them up with stainless pistons a couple of years ago.

Hi, I am planning a front axle change on my Land Rover 90 1984 vintage, the axle is from a Disco 1 and I was wondering if the early brake callipers will fit the later axle. TIA.

The difference in length is approx 10mm.

Solved, I have been sent front pistons:mad:.

Sorry, rear axle,

Hi, I was overhauling the brake callipers on an axle that I am going to fit to my LR 90, when I fitted the new stainless pistons they are approximately 10mm to long, the axle is off a Disco 1 but I'm not sure about the age, are there different lengths of piston? TIA.

Thanks guys, although I did earth the sender this was not a sound earth, so new earth and problem solved.

Hi, I have fitted a oil pressure gauge to my 90 and its not working properly so just asking if this sounds right for the wiring + on the gauge from live feed through the ignition, S on the gauge from the sensor on the T piece for the oil pressure switch and - on the gauge to earth. My problem is...

I bought a second hand set of series door trims of e bay fitted well, I had to modify them a little for my military door tops but that was expected, otherwise well made and fitted well.

A1203 It was striped right down to only the bulkhead, the out riggers have not been replaced as it is on a Galvanised chassis make unknown, I think it may be a Richards. One of the reasons fr the rebuild was the doors didn't fit very well, the bulkhead was to close to the tub, when I put it...

Hi thanks for all the reply's, I have decided to adjust the bulkhead to get the door gaps right. Whats the least I need to remove or loosen to achieve this, I know the roof to screen bolts will need to be loosened, will the wings need to be taken off or loosened? what about the floor? TIA.

All new strikers and locks, if its the bulkhead or tub that's out I am just going to leave it as its major work to adjust the bulkhead and I think the tub has no adjustment, anyway its way better than before I did the tub change, the drivers door was so tight it rubbed the B post near the top so...